Bunny Science
Bunny Science
Group: Registered
Joined: 2018/11/16
Noble Member
3
For visual orientation, this is the Magnum Mosquito. The cyl...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
Diagnosing New Onset Heat Creep Jams on Slice Magnum

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
Here are some test fittings/valve bodies being printed for M...

In forum Coronavirus (COVID-19)

11 months ago
Unfortunately, CPR valves are limited availability, expensiv...

In forum Coronavirus (COVID-19)

11 months ago
Here is STL for CPR valve adapter. It must be printed with r...

In forum Coronavirus (COVID-19)

11 months ago
Latest design testing has been regarding the outflow filters...

In forum Coronavirus (COVID-19)

11 months ago
Prusa MK3's create good quality prints in PETG. You will fin...

In forum Coronavirus (COVID-19)

11 months ago
I would need to go back through the firmware, but I vaguely ...

In forum Hardware, firmware and software help

12 months ago
Two reports of the loop fracturing like this without apparen...

In forum Coronavirus (COVID-19)

12 months ago
Ack! Wrong thread.

In forum Coronavirus (COVID-19)

12 months ago
Two reports of the loop fracturing like this without apparen...

In forum Coronavirus (COVID-19)

12 months ago
Does it leak with a brass nozzle?

In forum General discussion, announcements and releases

12 months ago
That is a combination of plasticizer loss from the PETG part...

In forum Hardware, firmware and software help

12 months ago
Yes, it can happen going from full power mode to stealth. St...

In forum Hardware, firmware and software help

12 months ago
Just backing up, what you mean by leaking is through the thr...

In forum General discussion, announcements and releases

12 months ago
I mean the ends of the nozzle and heat break. The ends are w...

In forum General discussion, announcements and releases

12 months ago
If heat break and nozzle are in tight contact and still leak...

In forum General discussion, announcements and releases

12 months ago
As @karl-herbert said, you can adjust steps in firmware to c...

In forum Assembly and first prints troubleshooting

12 months ago
Other than the zip tie clasps, other usual suspects... 1. Wi...

In forum Assembly and first prints troubleshooting

12 months ago
If you have not done the LIFE Z MY WAY process for getting Z...

In forum General discussion, announcements and releases

12 months ago
Page 3 / 74
Share:

Please Login or Register