Notifications
Clear all
Bunny Science
Bunny Science
Group: Registered
Joined: 2018/11/16
Noble Member
3
For visual orientation, this is the Magnum Mosquito. The cyl...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Diagnosing New Onset Heat Creep Jams on Slice Magnum

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Here are some test fittings/valve bodies being printed for M...

In forum Coronavirus (COVID-19)

1 year ago
Unfortunately, CPR valves are limited availability, expensiv...

In forum Coronavirus (COVID-19)

1 year ago
Here is STL for CPR valve adapter. It must be printed with r...

In forum Coronavirus (COVID-19)

1 year ago
Latest design testing has been regarding the outflow filters...

In forum Coronavirus (COVID-19)

1 year ago
Prusa MK3's create good quality prints in PETG. You will fin...

In forum Coronavirus (COVID-19)

1 year ago
I would need to go back through the firmware, but I vaguely ...

In forum Hardware, firmware and software help

1 year ago
Two reports of the loop fracturing like this without apparen...

In forum Coronavirus (COVID-19)

1 year ago
Ack! Wrong thread.

In forum Coronavirus (COVID-19)

1 year ago
Two reports of the loop fracturing like this without apparen...

In forum Coronavirus (COVID-19)

1 year ago
Does it leak with a brass nozzle?

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
That is a combination of plasticizer loss from the PETG part...

In forum Hardware, firmware and software help

1 year ago
Yes, it can happen going from full power mode to stealth. St...

In forum Hardware, firmware and software help

1 year ago
Just backing up, what you mean by leaking is through the thr...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I mean the ends of the nozzle and heat break. The ends are w...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
If heat break and nozzle are in tight contact and still leak...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
As @karl-herbert said, you can adjust steps in firmware to c...

In forum Assembly and first prints troubleshooting

1 year ago
Other than the zip tie clasps, other usual suspects... 1. Wi...

In forum Assembly and first prints troubleshooting

1 year ago
If you have not done the LIFE Z MY WAY process for getting Z...

In forum General discussion, announcements and releases

1 year ago
Page 3 / 74
Share: