Bunny Science
Bunny Science
Group: Registered
Joined: 2018/11/16
Noble Member
3
Is this really helpful ? Yes. 99.9% bidirectional viral filt...

In forum Coronavirus (COVID-19)

8 months ago
My Gourmia died after just over a year and a couple months. ...

In forum General discussion, announcements and releases

9 months ago
I tend to use contact z of 0.3 mm for my supports in PETG. T...

In forum General discussion, announcements and releases

9 months ago
I would simply put the desired LA value in the later execute...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
BTW, I found disabling SD card support in OctoPrint's "Featu...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
Anyway, the lesson here is that the Pi Zero compatibility is...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
Just like @paul-m27 I keep the pi's on 24/7 on their own pow...

In forum General discussion, announcements and releases

11 months ago
Pi 3B+ boards on my Prusas. I started with a zero, but very ...

In forum General discussion, announcements and releases

11 months ago
Use thetool to create your k-factor testing file. Use defaul...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
Yes. Both of mine are mirrored. Makes for easier servicing a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
On my MK3S Prusa framed machine, I simply cut the existing E...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
I would add the heatsinks and vent holes for EINSY enclosure...

In forum User mods - OctoPrint, enclosures, nozzles, ...

12 months ago
MacGyver team won the UCSF COVID Hackathon with BunnyPAPR! 😀...

In forum Coronavirus (COVID-19)

12 months ago
As noted earlier in this thread, I have heat sinks mounted o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

12 months ago
MacGuyver team completed their final UCSF COVID-19 Hackathon...

In forum Coronavirus (COVID-19)

1 year ago
If you are printing in PLA, do as Chocki wrote or lower the ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Without seeing the actual geometry, I will guess this is to ...

In forum How do I print this? (Printing help)

1 year ago
Bondtech set screw secure on motor shaft?

In forum How do I print this? (Printing help)

1 year ago
For better top surface consistency, I would increase number ...

In forum Assembly and first prints troubleshooting

1 year ago
Three hours into PETG print and no jamming. It would typical...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Page 1 / 74
Share:

Please Login or Register