Activity
 
Notifications
Clear all
Eddiie
Eddiie
Group: Registered
Joined: 2018/11/12
Eminent Member
2
One of the rubber feet on the bottom of the printer was not ...

In forum Hardware, firmware and software help

3 months ago
HELP!!! Unable to pass first layer calibration

In forum Hardware, firmware and software help

3 months ago
ohhh I see now. You made these in Meshmixer, which is what...

In forum General discussion, announcements and releases

3 years ago
Thank you for that but I was referring to the chess pieces t...

In forum General discussion, announcements and releases

3 years ago
Full RX Buffer

In forum Hardware, firmware and software help

3 years ago
yeah, need a lever to amplify the movement. also, if the fir...

In forum Assembly and first prints troubleshooting

3 years ago
We need a MMU Chess Set

In forum General discussion, announcements and releases

3 years ago
Interesting. I have a MMU2s. Much trouble getting the FIN...

In forum Awesome prints (Hall Of Fame)

3 years ago
Wow that is a nice benchy. Are you using the updated "S" mo...

In forum Awesome prints (Hall Of Fame)

3 years ago
Yeah - not Octoprint. I have 2 models that are of the same ...

In forum General discussion, announcements and releases

3 years ago
Oh I just fingered it out. Slic3r, Print Settings -> Laye...

In forum How do I print this? (Printing help)

3 years ago
How to change pathing in Slic3r..?

In forum How do I print this? (Printing help)

3 years ago
Yeah so that's what brings me here today. I have MK3S and ...

In forum How do I print this? (Printing help)

3 years ago
I restarted the print job and it did the same exact thing. ...

In forum General discussion, announcements and releases

3 years ago
I need these too, for the MK3S+MMU2S

In forum Hardware, firmware and software help

3 years ago
Yeah, I realized it wasnt going to work right after I turned...

In forum General discussion, announcements and releases

3 years ago
So much for that idea... Forgot I was using octoprint to se...

In forum General discussion, announcements and releases

3 years ago
Yeah, just slot 4. It was sliced in Slic3r PE, Single Mater...

In forum General discussion, announcements and releases

3 years ago
What do I do?

In forum General discussion, announcements and releases

3 years ago
The calibration points on the 7X7 should not be shifted left...

In forum General discussion, announcements and releases

3 years ago
Page 1 / 2
Share: