Notifications
Clear all
rick.f2
rick.f2
Group: Registered
Joined: 2018/11/11
Active Member
1
Thank you for the help. The bed has been cleaned with warm...

In forum How do I print this? (Printing help)

9 months ago
Printed parts separating about layer 80

In forum How do I print this? (Printing help)

9 months ago
@vintagepc Thank you for this info. I'll change my settings...

In forum How do I print this? (Printing help)

11 months ago
Slic3r settings for Lego bricks

In forum How do I print this? (Printing help)

11 months ago
@alec I think I've figured it out. I put a new hardened ste...

In forum Hardware, firmware and software help

1 year ago
@alec I hope it works for you. I'm having trouble with my l...

In forum Hardware, firmware and software help

1 year ago
I received the replacement Pinda today and the XYZ calibrati...

In forum Hardware, firmware and software help

1 year ago
@alec I haven't received the new Pinda yet. It should arriv...

In forum Hardware, firmware and software help

1 year ago
I had the same problem last week. Even when testing the pro...

In forum Hardware, firmware and software help

1 year ago
@mchughst Thank you. I spent about an hour on the live chat...

In forum Hardware, firmware and software help

1 year ago
@karl-herbert Thank you. I contacted Prusa chat and we reso...

In forum Assembly and first prints troubleshooting

1 year ago
@karl-herbert Thank you for your response. Everything is as...

In forum Assembly and first prints troubleshooting

1 year ago
A factory reset was performed and FW flashed. The self test...

In forum Assembly and first prints troubleshooting

1 year ago
@joantabb I haven't tried a factory reset, but I'll do that ...

In forum Assembly and first prints troubleshooting

1 year ago
XYZ calibration failure.

In forum Assembly and first prints troubleshooting

1 year ago
XYZ calibration failed. Bed calibration point was not found

In forum Hardware, firmware and software help

1 year ago
Share: