rick.f2
rick.f2
Group: Registered
Joined: 2018/11/11
Active Member
1
Thank you for the help. The bed has been cleaned with warm...

In forum How do I print this? (Printing help)

7 months ago
Printed parts separating about layer 80

In forum How do I print this? (Printing help)

7 months ago
@vintagepc Thank you for this info. I'll change my settings...

In forum How do I print this? (Printing help)

10 months ago
Slic3r settings for Lego bricks

In forum How do I print this? (Printing help)

10 months ago
@alec I think I've figured it out. I put a new hardened ste...

In forum Hardware, firmware and software help

12 months ago
@alec I hope it works for you. I'm having trouble with my l...

In forum Hardware, firmware and software help

12 months ago
I received the replacement Pinda today and the XYZ calibrati...

In forum Hardware, firmware and software help

12 months ago
@alec I haven't received the new Pinda yet. It should arriv...

In forum Hardware, firmware and software help

12 months ago
I had the same problem last week. Even when testing the pro...

In forum Hardware, firmware and software help

12 months ago
@mchughst Thank you. I spent about an hour on the live chat...

In forum Hardware, firmware and software help

12 months ago
@karl-herbert Thank you. I contacted Prusa chat and we reso...

In forum Assembly and first prints troubleshooting

12 months ago
@karl-herbert Thank you for your response. Everything is as...

In forum Assembly and first prints troubleshooting

12 months ago
A factory reset was performed and FW flashed. The self test...

In forum Assembly and first prints troubleshooting

12 months ago
@joantabb I haven't tried a factory reset, but I'll do that ...

In forum Assembly and first prints troubleshooting

12 months ago
XYZ calibration failure.

In forum Assembly and first prints troubleshooting

12 months ago
XYZ calibration failed. Bed calibration point was not found

In forum Hardware, firmware and software help

12 months ago
Share:

Please Login or Register