Activity
 
Notifications
Clear all
Tanner
Tanner
Group: Registered
Joined: 2018/11/09
Active Member
1
We finally got it out. The filament still stuck made it a b...

In forum Hardware, firmware and software help

2 years ago
@steve_g The filament won't budge. Even before I snipped it...

In forum Hardware, firmware and software help

2 years ago
Filament still inside Hotend but thermistor broken

In forum Hardware, firmware and software help

2 years ago
@neophyl So I've been printing a few little things here and ...

In forum Hardware, firmware and software help

2 years ago
I haven't changed much. Only on rectilinear infill does the...

In forum Hardware, firmware and software help

2 years ago
@ron So far there hasn't been any more dropping but I will l...

In forum Hardware, firmware and software help

2 years ago
@vintagepc Then why did Zodiac provide it?

In forum Hardware, firmware and software help

2 years ago
So while I still wait for the nylon cleaning filament, I fur...

In forum Hardware, firmware and software help

2 years ago
Hi @bobstro, I've removed the cooling duct, raised the tem...

In forum Hardware, firmware and software help

2 years ago
@bobstro I will try to get a wire brush and do the investiga...

In forum Hardware, firmware and software help

2 years ago
Burning Extrusion

In forum Hardware, firmware and software help

2 years ago
I figured it out. I ended up removing the nozzle, then rein...

In forum Hardware, firmware and software help

2 years ago
Edit: I will mention that I'm not sure why I turned off Only...

In forum Hardware, firmware and software help

2 years ago
Weird sploots and burnt plastic?

In forum Hardware, firmware and software help

2 years ago
I must say, I regret not posting my issues sooner. While I ...

In forum How do I print this? (Printing help)

3 years ago
Thanks for the answers. I'll look into reducing the Z-level...

In forum How do I print this? (Printing help)

3 years ago
I have not washed it with dish soap. I had wiped it with a ...

In forum How do I print this? (Printing help)

3 years ago
Prints lifting from textured bed

In forum How do I print this? (Printing help)

3 years ago
Share: