Thai Bui
Thai Bui
Group: Registered
Joined: 2018/10/23
Eminent Member
2
Filament grinding due to retraction (default settings)

In forum Assembly and first prints troubleshooting

3 months ago
Thanks guys for all the help. The latest 7x7 mesh bed leveli...

In forum Hardware, firmware and software help

2 years ago
So this is my printer trying this and as the picture is not ...

In forum Hardware, firmware and software help

2 years ago
i do use slic3r but i just use pronter to see how flat my be...

In forum Hardware, firmware and software help

2 years ago
then what could i do because the bottom corner that is low o...

In forum Hardware, firmware and software help

2 years ago
0.02283 0.01694 0.01550 0.01850 0.02594 0.03783 0.0541...

In forum Hardware, firmware and software help

2 years ago
This is just my pronterface level how could i make it level ...

In forum Hardware, firmware and software help

2 years ago
This is just my pronterface level how could i make it level ...

In forum Hardware, firmware and software help

2 years ago
would you think this is an acceptable mod.

In forum Hardware, firmware and software help

2 years ago
are these xyz calibration numbers good and if not which plan...

In forum Hardware, firmware and software help

2 years ago
Yes same bed i will change back to normal

In forum Hardware, firmware and software help

2 years ago
i just wanna know should i change back from this mod.

In forum Hardware, firmware and software help

2 years ago
Mk3 best mods

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
when i did that the bed still came out uneven

In forum Hardware, firmware and software help

2 years ago
This is just a quick example of the bed failing as the print...

In forum Hardware, firmware and software help

2 years ago
yes i use slicer all default settings maybe a little slower ...

In forum Hardware, firmware and software help

2 years ago
Mk3 when calibrating on pronter the bed is level but when pr...

In forum Hardware, firmware and software help

2 years ago
After a couple of changes the numbers have changed to these ...

In forum Assembly and first prints troubleshooting

2 years ago
Thanks for replying how about these numbers 0.03583 0.047...

In forum Assembly and first prints troubleshooting

2 years ago
After changing the screws on the bed and y carriage the bed ...

In forum Assembly and first prints troubleshooting

2 years ago
Page 1 / 2
Share:

Please Login or Register