Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Noble Member
3
I do the same with an adjustable wrench/spanner. I've not r...

In forum Hardware, firmware and software help

5 days ago
RE: Installing PrusaSlicer to Raspberry Pi 4

In forum General discussion, announcements and releases

5 days ago
It’s the purge block. It only appears if you have a multi co...

In forum PrusaSlicer

5 days ago
Not enough information to go on. You need to preferably post...

In forum PrusaSlicer

6 days ago
Not sure what you mean by weave but the dark blue areas on y...

In forum PrusaSlicer

6 days ago
@clarmrrsn Lol, there are a few people I could use that desc...

In forum Hardware, firmware and software help

6 days ago
Dash not "." Rated for 1 TO 5 Nm, which means its adjustable...

In forum Hardware, firmware and software help

6 days ago
Because the detect thin wall algorithm is different to the s...

In forum PrusaSlicer

6 days ago
I suspect one of the configuration updates was/is missing th...

In forum PrusaSlicer

6 days ago
@tfunder 3.5.3 is the first earliest version that mentions a...

In forum Hardware, firmware and software help

6 days ago
As I posted in the thread you linked you can use aligned rec...

In forum PrusaSlicer

7 days ago
You can also use the aligned rectilinear infill. However fo...

In forum PrusaSlicer

7 days ago
You NEED to also have the filament density in the filament s...

In forum PrusaSlicer

7 days ago
I'm not a beginner but I have never had much luck with pla s...

In forum Assembly and first prints troubleshooting

7 days ago
Its likely the grey filament then, if you were to disassembl...

In forum Hardware, firmware and software help

7 days ago
That's melted filament. Its caused by an improperly fitted ...

In forum Hardware, firmware and software help

7 days ago
The evo-stik type contact adhesive are very strong. At leas...

In forum General discussion, announcements and releases

7 days ago
@karl-herbert Yep that’s the type. Last time I bought some I...

In forum General discussion, announcements and releases

1 week ago
You are quite correct that the previous layer has not cooled...

In forum How do I print this? (Printing help)

1 week ago
That is certainly a legitimate concern. SuSie has way more ...

In forum PrusaSlicer

1 week ago
Page 2 / 123
Share:

Please Login or Register