Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Noble Member
3
As I posted in the thread you linked you can use aligned rec...

In forum PrusaSlicer

12 hours ago
You can also use the aligned rectilinear infill. However fo...

In forum PrusaSlicer

12 hours ago
You NEED to also have the filament density in the filament s...

In forum PrusaSlicer

12 hours ago
I'm not a beginner but I have never had much luck with pla s...

In forum Assembly and first prints troubleshooting

12 hours ago
Its likely the grey filament then, if you were to disassembl...

In forum Hardware, firmware and software help

12 hours ago
That's melted filament. Its caused by an improperly fitted ...

In forum Hardware, firmware and software help

14 hours ago
The evo-stik type contact adhesive are very strong. At leas...

In forum General discussion, announcements and releases

14 hours ago
@karl-herbert Yep that’s the type. Last time I bought some I...

In forum General discussion, announcements and releases

1 day ago
You are quite correct that the previous layer has not cooled...

In forum How do I print this? (Printing help)

2 days ago
That is certainly a legitimate concern. SuSie has way more ...

In forum PrusaSlicer

3 days ago
Contact adhesive, like Evo-Stik. Not sure what the equivale...

In forum General discussion, announcements and releases

3 days ago
Just to add to Bobs post, there have been a couple of posts ...

In forum General discussion, announcements and releases

3 days ago
Just use super slicer lol. I’m half kidding but the stable h...

In forum PrusaSlicer

3 days ago
Its called 'stringing'. It can be caused by a variety of th...

In forum Hardware, firmware and software help

4 days ago
Don't normally check the resin forum as I don't have one but...

In forum Hardware, firmware and software help

4 days ago
What Chad says is true if you just use a normal layer. Howev...

In forum Hardware, firmware and software help

5 days ago
Not that I’ve found no.

In forum General software discussion

5 days ago
@sherri No problem. The latest Blender releases since 2.8 ar...

In forum PrusaSlicer

5 days ago
Ok, I now say broken model 🙂 I imported the stl into PS2.3...

In forum PrusaSlicer

6 days ago
Is that part normally printed with 4 perimeters ? I suspect...

In forum PrusaSlicer

6 days ago
Page 1 / 121
Share:

Please Login or Register