Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Noble Member
3
@clarmrrsn Lol, there are a few people I could use that desc...

In forum Hardware, firmware and software help

1 hour ago
Dash not "." Rated for 1 TO 5 Nm, which means its adjustable...

In forum Hardware, firmware and software help

2 hours ago
Because the detect thin wall algorithm is different to the s...

In forum PrusaSlicer

3 hours ago
I suspect one of the configuration updates was/is missing th...

In forum PrusaSlicer

3 hours ago
@tfunder 3.5.3 is the first earliest version that mentions a...

In forum Hardware, firmware and software help

4 hours ago
As I posted in the thread you linked you can use aligned rec...

In forum PrusaSlicer

1 day ago
You can also use the aligned rectilinear infill. However fo...

In forum PrusaSlicer

1 day ago
You NEED to also have the filament density in the filament s...

In forum PrusaSlicer

1 day ago
I'm not a beginner but I have never had much luck with pla s...

In forum Assembly and first prints troubleshooting

1 day ago
Its likely the grey filament then, if you were to disassembl...

In forum Hardware, firmware and software help

1 day ago
That's melted filament. Its caused by an improperly fitted ...

In forum Hardware, firmware and software help

1 day ago
The evo-stik type contact adhesive are very strong. At leas...

In forum General discussion, announcements and releases

1 day ago
@karl-herbert Yep that’s the type. Last time I bought some I...

In forum General discussion, announcements and releases

2 days ago
You are quite correct that the previous layer has not cooled...

In forum How do I print this? (Printing help)

2 days ago
That is certainly a legitimate concern. SuSie has way more ...

In forum PrusaSlicer

3 days ago
Contact adhesive, like Evo-Stik. Not sure what the equivale...

In forum General discussion, announcements and releases

3 days ago
Just to add to Bobs post, there have been a couple of posts ...

In forum General discussion, announcements and releases

4 days ago
Just use super slicer lol. I’m half kidding but the stable h...

In forum PrusaSlicer

4 days ago
Its called 'stringing'. It can be caused by a variety of th...

In forum Hardware, firmware and software help

4 days ago
Don't normally check the resin forum as I don't have one but...

In forum Hardware, firmware and software help

5 days ago
Page 1 / 121
Share:

Please Login or Register