Notifications
Clear all
shilbert
shilbert
Group: Registered
Joined: 2018/10/12
Active Member
1
MMU2S has been criticized enough. The open approach makes it...

In forum Assembly and first prints troubleshooting

12 months ago
@marino Exactly. I used it for a while. It did not make thin...

In forum Assembly and first prints troubleshooting

12 months ago
@marino I had this mod for a while and it would not work con...

In forum Assembly and first prints troubleshooting

12 months ago
I have not read the entire thread but can add this. I had lo...

In forum Assembly and first prints troubleshooting

12 months ago
I see the same thing. IMHO the tip is larger then in multi c...

In forum Assembly and first prints troubleshooting

2 years ago
@rgordon0 Are you trying to flash from an Ubuntu system ? Yo...

In forum Hardware, firmware and software help

2 years ago
I remotely remember this problem. Never happened again when ...

In forum Hardware, firmware and software help

2 years ago
@andre-l9 I am using the first two mods mentioned and they w...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
The LED mod works great. Very helpful when you cannot get th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
@david-a66 If your really want to know what is going on:

In forum Hardware, firmware and software help

2 years ago
I have experienced the same thing. IMHO this is when the fil...

In forum Hardware, firmware and software help

2 years ago
@luca-vicini There are many selectors on thingiverse. Here i...

In forum Assembly and first prints troubleshooting

2 years ago
@thedevilsjester In one of the bags there was a spring that ...

In forum Assembly and first prints troubleshooting

2 years ago
@pierre-b11 Same here.

In forum Assembly and first prints troubleshooting

2 years ago
@andre-l9 I am using these mods successfully.

In forum Assembly and first prints troubleshooting

2 years ago
Your are not alone. I have been seeing the exact same thing....

In forum General discussion, announcements and releases

2 years ago
I experience the same thing.

In forum General discussion, announcements and releases

2 years ago
RE: Successful MMU2S Modifications (re-upload)

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
MMU2S - mixed results and some oberservations

In forum Assembly and first prints troubleshooting

2 years ago
Share: