Activity
 
Notifications
Clear all
tre4b
tre4b
Group: Registered
Joined: 2018/10/02
Eminent Member
2
Stopping a Print

In forum Hardware, firmware and software help

4 months ago
Thanks Wojciech, I found the way to sort this was to get O...

In forum Hardware, firmware and software help

4 months ago
Yeah, prusa bug by the look of it. If I use @pause as cust...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Does this resume heating too. For some reason when the paus...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Pause Printing - 3S with MMU2s

In forum Hardware, firmware and software help

4 months ago
I found the bondtech ones but could only buy the whole set f...

In forum Hardware, firmware and software help

4 months ago
Bondtech gear grub screw

In forum Hardware, firmware and software help

5 months ago
Not quite understanding what the magnet mod does? Been some...

In forum General discussion, announcements and releases

5 months ago
@xayoz I am on the latest update, so I think this is just so...

In forum Hardware, firmware and software help

1 year ago
@xayoz 3.9.0-3421 & 1.0.6-372. This only happens once ...

In forum Hardware, firmware and software help

1 year ago
MMU2s Fail to load loop

In forum Hardware, firmware and software help

1 year ago
Thanks neophyl, feels like this area needs a lot of work :-...

In forum PrusaSlicer

1 year ago
Is this slicers handling of Filament etc. as bad as it feels...

In forum PrusaSlicer

1 year ago
@jsw I usually don't but Covid-19 leaves us with too much t...

In forum General discussion, announcements and releases

2 years ago
I am just so glad I upgraded the firmware in my MM2s -- NOT!

In forum General discussion, announcements and releases

2 years ago
And this was a complete fail 🙁 Fought the setup file for...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Calibration of Z with a 0.8 nozzle

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Ta Neophyl. I seem to remember it saying something about d...

In forum PrusaSlicer

2 years ago
Slicer will not create supports where they are needed

In forum PrusaSlicer

2 years ago
It occurs to me that the only reason I need a customised ver...

In forum PrusaSlicer

2 years ago
Page 1 / 2
Share: