jwvaughn
jwvaughn
Group: Registered
Joined: 2018/09/28
Estimable Member
4
@cwbullet Hey! Thanks for the AliExpress tip on SunLo. When ...

In forum General discussion, announcements and releases

6 days ago
@jsw I never pursued the matter with Sunlo so no idea. On t...

In forum General discussion, announcements and releases

6 days ago
Amazon will ship PETG to California - Sunlo will not. I ask...

In forum General discussion, announcements and releases

6 days ago
If you have not done so, check that the grub screws on the e...

In forum Assembly and first prints troubleshooting

1 month ago
I would recommend running check disk then reinstalling the s...

In forum Hardware, firmware and software help

2 months ago
The AppData folder is normally hidden but you can enable dis...

In forum Hardware, firmware and software help

2 months ago
Yes, and it looks OK in that picture. Just to check if the m...

In forum Assembly and first prints troubleshooting

2 months ago
It is a bit hard to tell from the video but it looks to me l...

In forum Assembly and first prints troubleshooting

3 months ago
I didn't look very hard for small ones. The set I purchased...

In forum General discussion, announcements and releases

4 months ago
In PrusaSlicer, look under Print Settings/Layers and perimet...

In forum Assembly and first prints troubleshooting

4 months ago
Glad you got it out. I was wondering if extractors went smal...

In forum General discussion, announcements and releases

4 months ago
You might try a tool like this/p> I'm not recommending the b...

In forum General discussion, announcements and releases

4 months ago
For starters, your X motor pulley is reversed - the thick pa...

In forum Assembly and first prints troubleshooting

4 months ago
Glad you found the problem and happy printing 👍

In forum Hardware, firmware and software help

4 months ago
I listened to the video a couple of times and to my ear, it ...

In forum Hardware, firmware and software help

4 months ago
To add to the list of things to check - if the pulley is not...

In forum Assembly and first prints troubleshooting

4 months ago
I would gently clamp it with the nozzle facing up and then u...

In forum Hardware, firmware and software help

4 months ago
In regards to jsw's recommendations, I would add that if you...

In forum General discussion, announcements and releases

5 months ago
Thanks for the tip Tim, I am going to have to try it the nex...

In forum Hardware, firmware and software help

5 months ago
I started having problems with PETG blobbing up on the nozzl...

In forum Hardware, firmware and software help

5 months ago
Page 1 / 7
Share:

Please Login or Register