Activity
 
Notifications
Clear all
Chocki
Chocki
Group: Registered
Joined: 2018/09/27
Prominent Member
2
I'll try putting it in the dehydrator for a few hours and se...

In forum General discussion, announcements and releases

6 months ago
It's Prusa PC blend in black, and it is not sticking to this...

In forum General discussion, announcements and releases

6 months ago
So some time later.... PC doesn't stick well enough to this ...

In forum General discussion, announcements and releases

6 months ago
Bad news, these cards have been discontinued, any remaining ...

In forum Hardware, firmware and software help

7 months ago
Carry out a factory reset of the printer when you upgrade fi...

In forum Hardware, firmware and software help

7 months ago
Just be aware you will show ringing up more and possibly red...

In forum General discussion, announcements and releases

7 months ago
JohnDess beat me to it. Have you tried printing the external...

In forum General discussion, announcements and releases

7 months ago
I have used this filament before, and found it good, but be ...

In forum General discussion, announcements and releases

7 months ago
So, after trying and destroying various build surfaces, I ca...

In forum General discussion, announcements and releases

7 months ago
Polycarbonate printing on FYSETC textured sheet review

In forum General discussion, announcements and releases

7 months ago
The got2b hair spray direct on steel does not grip polycarbo...

In forum How do I print this? (Printing help)

8 months ago
Thanks Charles, I'd just add my pennies worth. I found PETG ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

8 months ago
Bed adhesion with polycarbonate question

In forum How do I print this? (Printing help)

8 months ago
Is that one of those "If you look carefully at this video, y...

In forum General discussion, announcements and releases

8 months ago
I always thought the glue stick was to help with adhesion, i...

In forum General discussion, announcements and releases

8 months ago
I'm going to be stupid enough to try buildtack black again w...

In forum General discussion, announcements and releases

8 months ago
Hmmm, the satin finish is desirable for an application I hav...

In forum General discussion, announcements and releases

8 months ago
And never try Polycarbonate on the black buildtack surface ☹

In forum General discussion, announcements and releases

8 months ago
also make the steepest overhang face forwards where the fan ...

In forum How do I print this? (Printing help)

8 months ago
Try less cooling and or slower printing speeds, if the layer...

In forum How do I print this? (Printing help)

8 months ago
Page 1 / 48
Share: