Activity
 
--
--
Group: Registered
Joined: 2018/09/10
Illustrious Member
Any attached USB cable nullifies any testing. The Einsy USB...

In forum Hardware, firmware and software help

5 months ago
Also - make sure you are selecting the proper sheet. I thin...

In forum General discussion, announcements and releases

5 months ago
I pour a puddle, about 50 mm, then scrub. I usually get a wh...

In forum General discussion, announcements and releases

5 months ago
To clear that type of jam, just heat the hot end up to 10c o...

In forum Hardware, firmware and software help

5 months ago
@sam-s7 It would be interesting to measure the thermistor of...

In forum Hardware, firmware and software help

5 months ago
Something else to try: try wiping the new part with the mark...

In forum General discussion, announcements and releases

5 months ago
Hard to tell from a photo - so I'll throw out a few ideas. ...

In forum General discussion, announcements and releases

5 months ago
@karl-herbert If PP power cable is reversed at one end, a di...

In forum Hardware, firmware and software help

5 months ago
Sounds more like you have multiple issues going on then. The...

In forum Hardware, firmware and software help

5 months ago
@fuchsr Similar to how MeshMixer allows painting tree suppor...

In forum PrusaSlicer

5 months ago
It would appear the Einsy is the issue; or, a broken wire in...

In forum Hardware, firmware and software help

5 months ago
As an FYI - glad the trick worked; but I've come to the conc...

In forum How do I print this? (Printing help)

5 months ago
Sounds like a simple bed heating issue, no voltage getting t...

In forum Hardware, firmware and software help

5 months ago
@james-watriss More of a case of being an early adopter who ...

In forum Hardware, firmware and software help

5 months ago
I created new x-carriage parts that allow the bearing to flo...

In forum General discussion, announcements and releases

5 months ago
That's where the paint function is handy. You can paint one ...

In forum PrusaSlicer

5 months ago
Also - read the Prusa manuals that come with the printer. AB...

In forum How do I print this? (Printing help)

5 months ago
Plicer 2.3.0.a has monotonic infill, which addresses the key...

In forum How do I print this? (Printing help)

5 months ago
And now the French links are showing 3.9.2, with the obscure...

In forum General discussion, announcements and releases

5 months ago
@james-watriss I have a full and complete Mk3 to Mk3s upgrad...

In forum Hardware, firmware and software help

5 months ago
Page 3 / 321
Share:

Please Login or Register