Activity
 
--
--
Group: Registered
Joined: 2018/09/10
Illustrious Member
Yeah - alcohol is quite good at spreading fingerprints aroun...

In forum General discussion, announcements and releases

3 months ago
Most of these issues are due to simply not ensuring the set ...

In forum Hardware, firmware and software help

3 months ago
And piling on - the time taken for a few long 180 mm/s moves...

In forum PrusaSlicer

3 months ago
SPAM - as always - kick the poster and delete the thread ......

In forum Awesome prints (Hall Of Fame)

3 months ago
The ears are not really attached to the dog's head. I loaded...

In forum How do I print this? (Printing help)

3 months ago
Here's the startup gcode I use to make the layer one more co...

In forum How do I print this? (Printing help)

3 months ago
@merrill-a No - not if the measurement was done in circuit. ...

In forum Hardware, firmware and software help

3 months ago
Using a hot wire is a mistake. Just use a plain old cold cop...

In forum Hardware, firmware and software help

3 months ago
On large flat areas you can try this technique - when tweake...

In forum Hardware, firmware and software help

3 months ago
Welcome to the forums. Before anyone has a chance of helpin...

In forum General discussion, announcements and releases

3 months ago
One might ask why you are printing it on a raft? Supports a...

In forum Hardware, firmware and software help

3 months ago
Last place to check to verify the Rambo driver is probably s...

In forum Hardware, firmware and software help

3 months ago
Smaller coupons are less dependent on adhesion - larger coup...

In forum General discussion, announcements and releases

3 months ago
In Slicer, File Export Project as 3MF - save the file, creat...

In forum How do I print this? (Printing help)

3 months ago
Just looked it up: it's now recommended 3 Nm; 2.2 ft-lbs, 2...

In forum Hardware, firmware and software help

3 months ago
ps: You might examine the heat bed - look for any areas wher...

In forum Hardware, firmware and software help

3 months ago
And you have verified the 15a fuse is good?

In forum Hardware, firmware and software help

3 months ago
Problems in Z are pretty rare. A few ideas: When you built t...

In forum Hardware, firmware and software help

3 months ago
Post a photo of the nozzle in the heater block. There is no...

In forum Hardware, firmware and software help

3 months ago
@vlejundo I think you might have been logged in and not yet ...

In forum General discussion, announcements and releases

3 months ago
Page 2 / 321
Share:

Please Login or Register