Activity
 
Tim
Tim
Group: Registered
Joined: 2018/09/10
Illustrious Member
Another thought is that when you add the cutouts for the voi...

In forum PrusaSlicer

3 hours ago
My theory on why speeding up the print works is that the pum...

In forum Hardware, firmware and software help

3 hours ago
When I had a similar problem, I swapped my heat break from t...

In forum Hardware, firmware and software help

4 hours ago
Line 37.5 is the problem. j/k ... Neophyl has a point. This ...

In forum Assembly and first prints troubleshooting

4 hours ago
Another possible roadblock here is some of these items might...

In forum Assembly and first prints troubleshooting

4 hours ago
TBH - in better light there are a few defects at the seam, m...

In forum How do I print this? (Printing help)

4 hours ago
Here's what I get. Sorry for the fuzz- my camera isn't actin...

In forum How do I print this? (Printing help)

5 hours ago
Dry bearings for sure. Yes - the bearings MUST be lubricated...

In forum Assembly and first prints troubleshooting

8 hours ago
Zip and post one of the stl files giving you grief ... the 3...

In forum Assembly and first prints troubleshooting

8 hours ago
It loads without issue here. Scale is a bit off, but switchi...

In forum Assembly and first prints troubleshooting

9 hours ago
Oh - and besides the first layer cal (runs the zigzag and sm...

In forum Assembly and first prints troubleshooting

9 hours ago
ps: ABS is not known to be sticky and often needs help; ABS ...

In forum Assembly and first prints troubleshooting

9 hours ago
In the menus, Calibration : First layer calibration ... If t...

In forum Assembly and first prints troubleshooting

9 hours ago
@obsessed I thought the printer tracks all axis... perhaps I...

In forum Hardware, firmware and software help

9 hours ago
Support fails because the bed is not clean. Any time PLA lif...

In forum How do I print this? (Printing help)

11 hours ago
@onur-inci Yes, you can overtighten the idler pully screw. T...

In forum Hardware, firmware and software help

11 hours ago
@julian-6 Once a print is done, I almost always move the bed...

In forum Hardware, firmware and software help

11 hours ago
Generally a clog; but can be the filament dragging somewhere...

In forum Hardware, firmware and software help

11 hours ago
Sanding is never required, nor is it a good idea. I did onc...

In forum Hardware, firmware and software help

12 hours ago
Verify both motors are engaged and running. You can swap the...

In forum Assembly and first prints troubleshooting

12 hours ago
Page 1 / 334
Share:

Please Login or Register