Notifications
Clear all
Patrick McNamara
Patrick McNamara
Group: Registered
Joined: 2018/09/05
Estimable Member
4
Caveat: I have a Mk3, not a mini. I only use the printer b...

In forum Hardware, firmware and software help

5 days ago
I changed my password and it went through without any odd pr...

In forum General discussion, announcements and releases

6 days ago
Oxidized steel is going to have an emissivity around 0.8. Gi...

In forum General discussion, announcements and releases

1 month ago
Some amount of insight into what you are looking for might h...

In forum General discussion, announcements and releases

6 months ago
I gave up trying to get the stupid forum software to display...

In forum Wie drucke ich das? (Hilfe zum Drucken)

8 months ago
Apologies, as I don't speak German. Google says -- "Ich spr...

In forum Wie drucke ich das? (Hilfe zum Drucken)

8 months ago
To follow up on something Joan referenced, what is your Z of...

In forum Assembly and first prints troubleshooting

10 months ago
I used the same thing as @kirby. Used the power panic board...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
Without seeing what the meter reads with the disconnected, t...

In forum Hardware, firmware and software help

11 months ago
You aren't going to find a 12V source inside the power suppl...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
I wanted to circle back to this, as I have identified the li...

In forum How do I print this? (Printing help)

12 months ago
Here are my thoughts. Looking on the bottom of the benchy. ...

In forum Assembly and first prints troubleshooting

1 year ago
Bearings are eating into the rod. Rotating the rod will hel...

In forum Hardware, firmware and software help

1 year ago
Given that you've replaced both motors, and tried swapping t...

In forum Assembly and first prints troubleshooting

1 year ago
The curve in the sides is due to the print warping while coo...

In forum How do I print this? (Printing help)

1 year ago
I did a series of prints using Sunlu PLA+ Black Silk, using ...

In forum Print tips (Archive)

1 year ago
Superlube #21030. You do not want the #92030 as it is an or...

In forum Hardware, firmware and software help

1 year ago
I followed the manual on my build, installed the bearings an...

In forum Hardware, firmware and software help

1 year ago
@sw3de Extrusion is a volume and a change in diameter is squ...

In forum General discussion, announcements and releases

1 year ago
When I am printing with a 0.25mm nozzle, I will print a cali...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 9
Share: