Notifications
Clear all
Swiss_Cheese
Swiss_Cheese
Group: Registered
Joined: 2018/08/29
Noble Member
3
LOL, I can live with the short ones vaporizing, it's the two...

In forum General discussion, announcements and releases

15 hours ago
@noel-d I'm in agreement with Jsw, your Z is off, I would ...

In forum Assembly and first prints troubleshooting

15 hours ago
@adriangarside Your really not going to like how I feel ab...

In forum How do I print this? (Printing help)

23 hours ago
I've had this happen to me several times here, it's very dis...

In forum General discussion, announcements and releases

23 hours ago
Hey that can be really fun, when I first started learning 3D...

In forum How do I print this? (Printing help)

24 hours ago
@matt-l I have several computers, some have Card readers a...

In forum Hardware, firmware and software help

1 day ago
A new sensor is $15.19 US plus shipping. I disabled mine yea...

In forum Hardware, firmware and software help

1 day ago
@ryan-f15 Of course you can, same as ever. they haven't ch...

In forum General discussion, announcements and releases

1 day ago
Thank goodness

In forum General discussion, announcements and releases

1 day ago
and hey lets not forget Ideamaker, but do dry your filament.

In forum How do I print this? (Printing help)

2 days ago
@freshairfanatic No obligation to take my advice, good l...

In forum How do I print this? (Printing help)

2 days ago
Why not just use Cura if that's what your used to? Prusa Sli...

In forum How do I print this? (Printing help)

2 days ago
Just dawned on me that I didn't address Medusa Stone Gray. R...

In forum General discussion, announcements and releases

2 days ago
I've printed with every single one of their ABS filaments I ...

In forum General discussion, announcements and releases

2 days ago
@buzz-2 I'll offer my experience, I have printed a great d...

In forum General discussion, announcements and releases

2 days ago
I'm not going by the pictures on the internet, I actually ha...

In forum General discussion, announcements and releases

2 days ago
Me either, thank you for the information though.

In forum General discussion, announcements and releases

3 days ago
I wasn't aware you were trying print rubber bands, you said ...

In forum General discussion, announcements and releases

3 days ago
@freshairfanatic You will need to slow down the print near...

In forum How do I print this? (Printing help)

3 days ago
I used to have tutorials, that I made, and would direct folk...

In forum PrusaSlicer

3 days ago
Page 1 / 72
Share: