Notifications
Clear all
Swiss_Cheese
Swiss_Cheese
Group: Registered
Joined: 2018/08/29
Noble Member
3
LOL, I can live with the short ones vaporizing, it's the two...

In forum General discussion, announcements and releases

16 hours ago
@noel-d I'm in agreement with Jsw, your Z is off, I would ...

In forum Assembly and first prints troubleshooting

16 hours ago
@adriangarside Your really not going to like how I feel ab...

In forum How do I print this? (Printing help)

23 hours ago
I've had this happen to me several times here, it's very dis...

In forum General discussion, announcements and releases

1 day ago
Hey that can be really fun, when I first started learning 3D...

In forum How do I print this? (Printing help)

1 day ago
@matt-l I have several computers, some have Card readers a...

In forum Hardware, firmware and software help

1 day ago
A new sensor is $15.19 US plus shipping. I disabled mine yea...

In forum Hardware, firmware and software help

1 day ago
@ryan-f15 Of course you can, same as ever. they haven't ch...

In forum General discussion, announcements and releases

2 days ago
Thank goodness

In forum General discussion, announcements and releases

2 days ago
and hey lets not forget Ideamaker, but do dry your filament.

In forum How do I print this? (Printing help)

2 days ago
@freshairfanatic No obligation to take my advice, good l...

In forum How do I print this? (Printing help)

2 days ago
Why not just use Cura if that's what your used to? Prusa Sli...

In forum How do I print this? (Printing help)

2 days ago
Just dawned on me that I didn't address Medusa Stone Gray. R...

In forum General discussion, announcements and releases

2 days ago
I've printed with every single one of their ABS filaments I ...

In forum General discussion, announcements and releases

2 days ago
@buzz-2 I'll offer my experience, I have printed a great d...

In forum General discussion, announcements and releases

2 days ago
I'm not going by the pictures on the internet, I actually ha...

In forum General discussion, announcements and releases

2 days ago
Me either, thank you for the information though.

In forum General discussion, announcements and releases

3 days ago
I wasn't aware you were trying print rubber bands, you said ...

In forum General discussion, announcements and releases

3 days ago
@freshairfanatic You will need to slow down the print near...

In forum How do I print this? (Printing help)

3 days ago
I used to have tutorials, that I made, and would direct folk...

In forum PrusaSlicer

3 days ago
Page 1 / 72
Share: