Notifications
Clear all
Swiss_Cheese
Swiss_Cheese
Group: Registered
Joined: 2018/08/29
Noble Member
3
@angelsvenom Well first of all, I specifically said I woul...

In forum How do I print this? (Printing help)

23 hours ago
@angelsvenom I had developed a "technique" for exactly t...

In forum How do I print this? (Printing help)

23 hours ago
while I'm chastising for using alpha 2.4_3 for this, Ringarn...

In forum How do I print this? (Printing help)

2 days ago
It would make little to no sense to try and do a production ...

In forum How do I print this? (Printing help)

3 days ago
@jsw It's better then you might be thinking, I use it on P...

In forum How do I print this? (Printing help)

4 days ago
Have you thought about conductive silver epoxy ? MG Chemic...

In forum How do I print this? (Printing help)

4 days ago
@cwbullet Just to be clear, you asked for suggestions ...

In forum General discussion, announcements and releases

4 days ago
@jimd Ok, this is not a simple question, however the simple ...

In forum How do I print this? (Printing help)

5 days ago
I'm not clear on what your asking, do you mean how did I kno...

In forum How do I print this? (Printing help)

5 days ago
Printed these yesterday before my first post to verify orien...

In forum General discussion, announcements and releases

5 days ago
I'd print it like this. Regards Swiss_Cheese

In forum General discussion, announcements and releases

6 days ago
@towlerg Bottom layers bridges PrusaSlicer is based ...

In forum PrusaSlicer

6 days ago
Nominally 200g Regards Swiss_Cheese

In forum General discussion, announcements and releases

6 days ago
@dan-rogers I'll try to explain some about the modifie...

In forum How do I print this? (Printing help)

1 week ago
@towlerg Thick Bridges (off) is the default setting, you w...

In forum PrusaSlicer

1 week ago
@dan-rogers It's up to you, but I'd go ahead and post, yo...

In forum How do I print this? (Printing help)

1 week ago
@jimd I forgot to mention, and this is important, when you o...

In forum How do I print this? (Printing help)

1 week ago
@jimd Try these settings, I did some tuning so you may...

In forum How do I print this? (Printing help)

1 week ago
@jimd I'm working on a solution (Tuned your print settings...

In forum How do I print this? (Printing help)

1 week ago
@towlerg Ok, I'll do it. @adamade You have two ways ...

In forum PrusaSlicer

1 week ago
Page 1 / 61
Share: