Notifications
Clear all
Swiss_Cheese
Swiss_Cheese
Group: Registered
Joined: 2018/08/29
Noble Member
3
This is not adequate, you need 70C active drying, meaning 35...

In forum How do I print this? (Printing help)

14 hours ago
well, if it makes a difference the printer I'm referring to ...

In forum Hardware, firmware and software help

1 day ago
I use pure sine, for this very reason steped sine will not c...

In forum Hardware, firmware and software help

1 day ago
@towlerg Yes I like you. Swiss_Cheese

In forum PrusaSlicer

1 day ago
@julian-5 would you care to post a Zipped up .3mf project ...

In forum PrusaSlicer

1 day ago
@tm_akman In many cases it is caused by the solid infi...

In forum How do I print this? (Printing help)

1 day ago
@tm_akman I think this print can still be tuned better, I'...

In forum How do I print this? (Printing help)

1 day ago
@tm_akman I might try something like this. Beaver tail S...

In forum How do I print this? (Printing help)

2 days ago
@towlerg Sorry to hear about your machine, and thank you f...

In forum PrusaSlicer

2 days ago
@steve-9 some friendly advice, when you ask for help, and ...

In forum PrusaSlicer

2 days ago
@steve-9 Try this, it's setup for manual color changes, le...

In forum PrusaSlicer

2 days ago
@steve-9 If you would care to post a Zipped up .3mf projec...

In forum PrusaSlicer

2 days ago
@towlerg I don't use alpha software versions, could yo...

In forum PrusaSlicer

4 days ago
@deansword I'm guessing after reading through this thread ...

In forum PrusaSlicer

4 days ago
@navajas your welcome, and yes. In this case I did it in...

In forum How do I print this? (Printing help)

4 days ago
Height range modifiers and modifier meshes don't play well t...

In forum PrusaSlicer

4 days ago
Your welcome Doctor. Swiss_Cheese

In forum PrusaSlicer

4 days ago
@efezeta This_Swiss.Zip Let us know how it goes, Swiss...

In forum How do I print this? (Printing help)

4 days ago
@navajas Slicer used to allow this behavior, to have p...

In forum How do I print this? (Printing help)

4 days ago
@navajas You have to zip up your .3mf files before the ser...

In forum How do I print this? (Printing help)

5 days ago
Page 1 / 57
Share: