Notifications
Clear all
Swiss_Cheese
Swiss_Cheese
Group: Registered
Joined: 2018/08/29
Noble Member
3
Me either, thank you for the information though.

In forum General discussion, announcements and releases

14 hours ago
I wasn't aware you were trying print rubber bands, you said ...

In forum General discussion, announcements and releases

15 hours ago
@freshairfanatic You will need to slow down the print near...

In forum How do I print this? (Printing help)

15 hours ago
I used to have tutorials, that I made, and would direct folk...

In forum PrusaSlicer

17 hours ago
Ninjaflex is a TPU it's durometer 85A it makes great drive b...

In forum General discussion, announcements and releases

18 hours ago
You can do this with mesh modifiers, in slicer. Regards ...

In forum PrusaSlicer

18 hours ago
Ninjaflex Regards Swiss_Cheese

In forum General discussion, announcements and releases

18 hours ago
If it was me I'd start off with Adobe Illustrator and trace ...

In forum How do I print this? (Printing help)

19 hours ago
@hondanickx I'm just throwing this out there, just in case...

In forum How do I print this? (Printing help)

19 hours ago
@yveske Thanks for the Info, I was completely unaware they...

In forum General discussion, announcements and releases

1 day ago
Don't know what you think you won, was never aware of any co...

In forum General discussion, announcements and releases

1 day ago
Ok, I'll give, you know more then I gave you credit for, I'l...

In forum PrusaSlicer

1 day ago
In what way? what is that based on? forgive me LOL LOL

In forum PrusaSlicer

1 day ago
@max-8 You know Max, this is not aimed at you, but we have...

In forum Assembly and first prints troubleshooting

1 day ago
@charles I agree but the shear number of these kind of posts...

In forum Assembly and first prints troubleshooting

2 days ago
It sure does seem like I've been seeing a lot of this lately...

In forum Assembly and first prints troubleshooting

2 days ago
@sander I feel Deim was very helpful with his comments...

In forum Hardware, firmware and software help

2 days ago
@briancadtec3d-co-uk welcome to the forum. well, for starter...

In forum How do I print this? (Printing help)

2 days ago
Yes, you can do this. I'm guessing your using Prusa slicer...

In forum PrusaSlicer

2 days ago
@florian-redl The .STL seems to be a bit messy, if pos...

In forum PrusaSlicer

2 days ago
Page 1 / 71
Share: