Notifications
Clear all
Swiss_Cheese
Swiss_Cheese
Group: Registered
Joined: 2018/08/29
Noble Member
3
@matt-l I have several computers, some have Card readers a...

In forum Hardware, firmware and software help

7 hours ago
A new sensor is $15.19 US plus shipping. I disabled mine yea...

In forum Hardware, firmware and software help

10 hours ago
@ryan-f15 Of course you can, same as ever. they haven't ch...

In forum General discussion, announcements and releases

10 hours ago
Thank goodness

In forum General discussion, announcements and releases

11 hours ago
and hey lets not forget Ideamaker, but do dry your filament.

In forum How do I print this? (Printing help)

12 hours ago
@freshairfanatic No obligation to take my advice, good l...

In forum How do I print this? (Printing help)

13 hours ago
Why not just use Cura if that's what your used to? Prusa Sli...

In forum How do I print this? (Printing help)

13 hours ago
Just dawned on me that I didn't address Medusa Stone Gray. R...

In forum General discussion, announcements and releases

13 hours ago
I've printed with every single one of their ABS filaments I ...

In forum General discussion, announcements and releases

14 hours ago
@buzz-2 I'll offer my experience, I have printed a great d...

In forum General discussion, announcements and releases

22 hours ago
I'm not going by the pictures on the internet, I actually ha...

In forum General discussion, announcements and releases

23 hours ago
Me either, thank you for the information though.

In forum General discussion, announcements and releases

2 days ago
I wasn't aware you were trying print rubber bands, you said ...

In forum General discussion, announcements and releases

2 days ago
@freshairfanatic You will need to slow down the print near...

In forum How do I print this? (Printing help)

2 days ago
I used to have tutorials, that I made, and would direct folk...

In forum PrusaSlicer

2 days ago
Ninjaflex is a TPU it's durometer 85A it makes great drive b...

In forum General discussion, announcements and releases

2 days ago
You can do this with mesh modifiers, in slicer. Regards ...

In forum PrusaSlicer

2 days ago
Ninjaflex Regards Swiss_Cheese

In forum General discussion, announcements and releases

2 days ago
If it was me I'd start off with Adobe Illustrator and trace ...

In forum How do I print this? (Printing help)

2 days ago
@hondanickx I'm just throwing this out there, just in case...

In forum How do I print this? (Printing help)

2 days ago
Page 1 / 72
Share: