Notifications
Clear all
Laura F Farrell
Laura F Farrell
Group: Registered
Joined: 2018/08/22
Trusted Member
3
Depends on how much you print. With a LOT of printing, I got...

In forum General discussion, announcements and releases

4 weeks ago
If you have a look at github you'll probably find the specif...

In forum General discussion, announcements and releases

4 weeks ago
I did have an issue like this, and from what I remember it w...

In forum Hardware, firmware and software help

2 months ago
Same here - I switched from MK3 to MK3S not long after it ca...

In forum General discussion, announcements and releases

2 months ago
I find drying TPU helps immensely, as does keeping tension o...

In forum How do I print this? (Printing help)

2 months ago
I find drying TPU helps immensely, as does keeping tension o...

In forum How do I print this? (Printing help)

2 months ago
To revive this very old thread in fairness to Colorfabb, som...

In forum How do I print this? (Printing help)

2 months ago
@megardstudio Check your fan is working properly and there i...

In forum Hardware, firmware and software help

5 months ago
In Europe a new thermistor costs under 10 euros, easier to b...

In forum Hardware, firmware and software help

5 months ago
Should I replace all the caked up parts, or should I upgrade...

In forum Hardware, firmware and software help

7 months ago
Lots of things this could be: 1. I find the textured sheet t...

In forum Assembly and first prints troubleshooting

7 months ago
Glue, glue, glue! (for nylon or PC)

In forum How do I print this? (Printing help)

10 months ago
@cwbullet The new R6 parts might fix that. I print in Polyma...

In forum General discussion, announcements and releases

11 months ago
I would second the suggestion to increase temperatures on no...

In forum How do I print this? (Printing help)

12 months ago
I can't answer for the Prusa PC blend but I print quite a bi...

In forum How do I print this? (Printing help)

12 months ago
An issue I have come accross very occasionally is when the b...

In forum Hardware, firmware and software help

12 months ago
@joantabb Agreed with Joan. Just to point out that for me th...

In forum Hardware, firmware and software help

12 months ago
This is a glorious upgrade. I put one of these in over a yea...

In forum Hardware, firmware and software help

1 year ago
@gnat To be fair I had this issue with a particular filament...

In forum General discussion, announcements and releases

1 year ago
@charles-h13 agreed - the zip ties are very tidy and easy to...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 4
Share: