Notifications
Clear all
Mike01Hu
Mike01Hu
Group: Registered
Joined: 2018/07/19
Active Member
1
@swiss_cheese Thanks. Yes, I knew that and had shifted the t...

In forum How do I print this? (Printing help)

12 months ago
Prusament Galaxy Black delamination

In forum How do I print this? (Printing help)

12 months ago
@tim-m30 Thanks Tim

In forum Improvements (Archive)

2 years ago
@tim-m30 Yes, my comment was to point to the issue but I lik...

In forum Improvements (Archive)

2 years ago
As @bobstro and @guy-k2 indicate the issue is due to the sta...

In forum Improvements (Archive)

2 years ago
@nikolai-r Without a MMU colour changes are only implemented...

In forum Improvements (Archive)

2 years ago
Filament holder issue

In forum Improvements (Archive)

2 years ago
Power-fail restart failures

In forum Hardware, firmware and software help

2 years ago
I note that there was no improvement in the power-fail recov...

In forum General discussion, announcements and releases

2 years ago
As I have been a 3D printer user as a design Engineer for al...

In forum Assembly and first prints troubleshooting

2 years ago
Extruder idler tensioner issue

In forum Assembly and first prints troubleshooting

2 years ago
Mk3 Printed model accuracy

In forum General discussion, announcements and releases

3 years ago
My build resulted in a perfect alignment result but I still ...

In forum Assembly and first prints troubleshooting

3 years ago
Successful build and first prints

In forum Assembly and first prints troubleshooting

3 years ago
As mentioned above, the silicon sock is a solution for PETG ...

In forum Assembly and first prints troubleshooting

3 years ago
Share: