cwbullet
cwbullet
Group: Registered
Joined: 2018/07/13
Illustrious Member
@darrindevine I have gotten Filimentum TPU to print with Sai...

In forum General discussion, announcements and releases

2 hours ago
I am not sure what you are saying. Are you saying the Bondt...

In forum Hardware, firmware and software help

2 hours ago
@adesir From my iPhone, it think you are right but I do not ...

In forum General discussion, announcements and releases

2 hours ago
How many years old is your oldest printer that is still prin...

In forum General discussion, announcements and releases

2 hours ago
That is for another thread.

In forum General discussion, announcements and releases

2 hours ago
@neophyl It is bad out of the box. I have it working fairly...

In forum PrusaSlicer

2 hours ago
I would recommend a complete disassembly and reassembly of t...

In forum Hardware, firmware and software help

5 hours ago
@customs302 The max low level is nozzle and pinda touching t...

In forum Assembly and first prints troubleshooting

5 hours ago
@alistair-3

In forum General discussion, announcements and releases

5 hours ago
Odd. I would report this to the DEVs on Github.

In forum PrusaSlicer

6 hours ago
No. Disassembly will require you to make too many adjustmen...

In forum General discussion, announcements and releases

6 hours ago
@towlerg That is certainly true.

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 hours ago
@towlerg That is certainly true.

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 hours ago
@clarmrrsn It must be a bad link.

In forum Hardware, firmware and software help

6 hours ago
@swiss_cheese I concur. I just thought it was a fun discuss...

In forum General discussion, announcements and releases

6 hours ago
@dan-rogers I did not use any chemicals.

In forum User mods - OctoPrint, enclosures, nozzles, ...

13 hours ago
@crawlerin I think you are right. I am always concerned abo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

13 hours ago
@dan-rogers I have a couple of sheets without rust - there i...

In forum User mods - OctoPrint, enclosures, nozzles, ...

13 hours ago
Agreed learn one sheet and get good at it before swapping.

In forum Assembly and first prints troubleshooting

15 hours ago
Freezer approach - I like it.

In forum User mods - OctoPrint, enclosures, nozzles, ...

16 hours ago
Page 1 / 336
Share:

Please Login or Register