cwbullet
cwbullet
Group: Registered
Joined: 2018/07/13
Illustrious Member
@clarmrrsn I have agree they are worthless. I just can’t ev...

In forum Coronavirus (COVID-19)

2 hours ago
Blastphomy. Who tires of orange?

In forum General discussion, announcements and releases

3 hours ago
I will give this a try tonight. I have one that is a little...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 hours ago
I read the article from Duke and the researchers in their an...

In forum Coronavirus (COVID-19)

3 hours ago
@alexxriot It is virtual if not completely possible for a fa...

In forum Coronavirus (COVID-19)

3 hours ago
If I see wavy lines, I pack off -0.020 until they go away.

In forum How do I print this? (Printing help)

16 hours ago
@lize I will have to try that one.

In forum How do I print this? (Printing help)

1 day ago
Your Z could also be too negative.

In forum How do I print this? (Printing help)

2 days ago
I would definitely loosen the idler screw just a touch and t...

In forum Assembly and first prints troubleshooting

2 days ago
@lung I have ordered by mistake 2.85 mm parts a couple of ti...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 days ago
California filament has a special - 20% off if you order 3 r...

In forum General discussion, announcements and releases

2 days ago
Also, are you telling it to “change filament” under “Tune”? ...

In forum Hardware, firmware and software help

2 days ago
@doctorrudd Then Prusa's initial offering is not for you. T...

In forum General discussion, announcements and releases

2 days ago
@daryl-2 That works if you rough it up.

In forum Hardware, firmware and software help

2 days ago
@boatbuilder Good points. Thanks.

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 days ago
@3djoe California filament is a quality vendor if you need P...

In forum General discussion, announcements and releases

3 days ago
woohoo! I thought this was a new or special edition model b...

In forum General discussion, announcements and releases

3 days ago
@eirlink That is hillarious. Enjoy your Haribos.

In forum General discussion, announcements and releases

3 days ago
@gregor-2 enjoy!

In forum General discussion, announcements and releases

3 days ago
Prusa XL. I prefer the support and tested software behind i...

In forum General discussion, announcements and releases

3 days ago
Page 1 / 313
Share:

Please Login or Register