Prusa3D Forum

cwbullet

Group: Registered

Joined: 2018/07/13

Illustrious Member

	@clarmrrsn I have agree they are worthless. I just can’t ev... In forum Coronavirus (COVID-19)	5 hours ago
	Blastphomy. Who tires of orange? In forum General discussion, announcements and releases	6 hours ago
	I will give this a try tonight. I have one that is a little... In forum User mods - OctoPrint, enclosures, nozzles, ...	6 hours ago
	I read the article from Duke and the researchers in their an... In forum Coronavirus (COVID-19)	6 hours ago
	@alexxriot It is virtual if not completely possible for a fa... In forum Coronavirus (COVID-19)	6 hours ago
	If I see wavy lines, I pack off -0.020 until they go away. In forum How do I print this? (Printing help)	19 hours ago
	@lize I will have to try that one. In forum How do I print this? (Printing help)	1 day ago
	Your Z could also be too negative. In forum How do I print this? (Printing help)	2 days ago
	I would definitely loosen the idler screw just a touch and t... In forum Assembly and first prints troubleshooting	2 days ago
	@lung I have ordered by mistake 2.85 mm parts a couple of ti... In forum User mods - OctoPrint, enclosures, nozzles, ...	2 days ago
	California filament has a special - 20% off if you order 3 r... In forum General discussion, announcements and releases	2 days ago
	Also, are you telling it to “change filament” under “Tune”? ... In forum Hardware, firmware and software help	2 days ago
	@doctorrudd Then Prusa's initial offering is not for you. T... In forum General discussion, announcements and releases	2 days ago
	@daryl-2 That works if you rough it up. In forum Hardware, firmware and software help	3 days ago
	@boatbuilder Good points. Thanks. In forum User mods - OctoPrint, enclosures, nozzles, ...	3 days ago
	@3djoe California filament is a quality vendor if you need P... In forum General discussion, announcements and releases	3 days ago
	woohoo! I thought this was a new or special edition model b... In forum General discussion, announcements and releases	3 days ago
	@eirlink That is hillarious. Enjoy your Haribos. In forum General discussion, announcements and releases	3 days ago
	@gregor-2 enjoy! In forum General discussion, announcements and releases	3 days ago
	Prusa XL. I prefer the support and tested software behind i... In forum General discussion, announcements and releases	3 days ago

Page 1 / 313 Next

Forum Statistics

397 Forums

37.3 K Topics

273.3 K Posts

93 Online

54.9 K Members

Latest Post: Underextrusion on far right side due to the bowden design Our newest member: c_ertter Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts Mark all read

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed