cwbullet
cwbullet
Group: Registered
Joined: 2018/07/13
Illustrious Member
I use Viva low lint paper towels or the blue ones from Lowes...

In forum General discussion, announcements and releases

6 hours ago
I would have to agree. I can't wait for Prusa Connect and t...

In forum General discussion, announcements and releases

16 hours ago
@g-monkey I have my printer in an enclosure and it is about ...

In forum General discussion, announcements and releases

20 hours ago
You have a jam. Try heating it up 10 degrees warmer. If th...

In forum Hardware, firmware and software help

22 hours ago
@chocki It did not work for every sPool I have, but it work ...

In forum General discussion, announcements and releases

22 hours ago
No update and march is long gone. Soon April will be in the...

In forum General discussion, announcements and releases

22 hours ago
@mrstoned If you have to ask, yes.

In forum General discussion, announcements and releases

22 hours ago
Bondtech - I added it to replace a PTFE line heat break. It...

In forum Hardware, firmware and software help

23 hours ago
@dan-rogers I think that is part of the problem with a lot o...

In forum Hardware, firmware and software help

2 days ago
@jerry Point taken.

In forum General discussion, announcements and releases

2 days ago
@g-monkey I have had similar results with and without an enc...

In forum General discussion, announcements and releases

2 days ago
@towlerg So it stops working?

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 days ago
I would adjust the pinda down a notch or two and start at ze...

In forum Assembly and first prints troubleshooting

2 days ago
That Z is ok, but it is a little high.

In forum Assembly and first prints troubleshooting

2 days ago
Pretty nice prints. Enjoy!

In forum General discussion, announcements and releases

2 days ago
@eirlink That is probably the best first player test I have ...

In forum Assembly and first prints troubleshooting

2 days ago
I finally added a second filament sensor to make sure octopr...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
@clemens-m No doubt that dry filament prints better.

In forum General discussion, announcements and releases

3 days ago
Forget the broken wire. That is not possible based on your ...

In forum Assembly and first prints troubleshooting

3 days ago
@fuchsr Don't forget Printed Solid and Filastruder. Both se...

In forum Hardware, firmware and software help

3 days ago
Page 1 / 316
Share:

Please Login or Register