cwbullet
cwbullet
Group: Registered
Joined: 2018/07/13
Illustrious Member
I suggest that you contact support via the chat on the eShop...

In forum Hardware, firmware and software help

4 days ago
Good reference:

In forum Hardware, firmware and software help

4 days ago
You probably have a broken bed thermistor wire. You can rep...

In forum Hardware, firmware and software help

4 days ago
Yup. It is been reported in several other threads and confi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 days ago
@azs9 PM me here. Not much for facebook.

In forum Hardware, firmware and software help

5 days ago
I am pretty sure that R6 is the new part. Contact support v...

In forum Hardware, firmware and software help

5 days ago
Looks pretty good. Better than I could get with the old MMU...

In forum General discussion, announcements and releases

5 days ago
I will have to remember that one. I am not sure I have hear...

In forum Hardware, firmware and software help

6 days ago
@ssill2 Looks a lot like stain glass. How hard was it to ge...

In forum How do I print this? (Printing help)

6 days ago
@jerry-s Good news. Going to opposite direction and ignorin...

In forum Hardware, firmware and software help

6 days ago
Is the light lighting up on the SPINDA on the last spot?

In forum Assembly and first prints troubleshooting

7 days ago
@technical-ted Bingo. The purge line is not a good tell for...

In forum Hardware, firmware and software help

7 days ago
That looks like a layer shift. Did you lubricate your beari...

In forum How do I print this? (Printing help)

7 days ago
The image is a bit too close. It could be a layer shift but...

In forum Hardware, firmware and software help

7 days ago
That is pretty slick! I am regretting going on vacation. I...

In forum How do I print this? (Printing help)

1 week ago
Have you contacted support via Chat? That is where I would ...

In forum Hardware, firmware and software help

1 week ago
@kai-4 Nice find. I am going to have to install this one of...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 week ago
@rjbram Make sure your nozzle is not too close to the bed. ...

In forum Assembly and first prints troubleshooting

1 week ago
I would guess you are still too high. The only other thing ...

In forum How do I print this? (Printing help)

1 week ago
@annier Did you prime it first? Ignore my question. I saw...

In forum How do I print this? (Printing help)

1 week ago
Page 2 / 382
Share:

Please Login or Register