cwbullet
cwbullet
Group: Registered
Joined: 2018/07/13
Illustrious Member
Is the filament drive gear chewing up the filament? If so,...

In forum Assembly and first prints troubleshooting

1 hour ago
@customs302 Are you printing on a raft?

In forum Assembly and first prints troubleshooting

1 hour ago
The issue I have is that I often print at 260-280. I might ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 hours ago
Quite a few folks have had issues with the M1 Macs. Not sur...

In forum PrusaSlicer

5 hours ago
I did not make any adjustments and it worked well enough for...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 hours ago
@el-jefe-vador I think soap and water works on all surfaces ...

In forum Assembly and first prints troubleshooting

12 hours ago
Retraction is certainly a possibility but I cannot figure wh...

In forum Hardware, firmware and software help

12 hours ago
@john-doe-3 Very nice design. You should test it out and ad...

In forum User mods - OctoPrint, enclosures, nozzles, ...

12 hours ago
I would go to: and find someone local who would be willing ...

In forum Hardware, firmware and software help

20 hours ago
I would recommend you contact support via eChat on this one....

In forum General discussion, announcements and releases

1 day ago
@livius What filament did you use?

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 day ago
Bob, Did you mean Paramount? The link does to them and not...

In forum General discussion, announcements and releases

2 days ago
I think the most common printed part to fail is the fan shro...

In forum General discussion, announcements and releases

2 days ago
Yes. Most who move to the Mosquito do so because they want ...

In forum Hardware, firmware and software help

3 days ago
Can you take some more pictures? This may be too close. Al...

In forum How do I print this? (Printing help)

3 days ago
Small amounts are probably ok, I would avoid sleeping beside...

In forum General discussion, announcements and releases

3 days ago
Do you mean clone? I do not think there is a clone of the M...

In forum General discussion, announcements and releases

4 days ago
What filament brand? Are you sure it is dry? You could po...

In forum Hardware, firmware and software help

4 days ago
@kuchenloch Well, tomorrow you will know. I have not seen a...

In forum Hardware, firmware and software help

4 days ago
To confirm, Which printer are you using and how old is it?

In forum Hardware, firmware and software help

4 days ago
Page 1 / 382
Share:

Please Login or Register