Activity
 
Notifications
Clear all
JBinFL
JBinFL
Group: Registered
Joined: 2018/06/21
Reputable Member
5
To add to Bobstro's post, yes, your live z is clearly too lo...

In forum Assembly and first prints troubleshooting

1 year ago
Yes, that was the first thing I thought of too. Or it could...

In forum General discussion, announcements and releases

1 year ago
Tim-M30 & Karl: Thank you for the responses, as I was co...

In forum Hardware, firmware and software help

1 year ago
Drivers Question version 2_3_0 ???

In forum Hardware, firmware and software help

1 year ago
This video, which is older, has some good tips on extruder i...

In forum Assembly and first prints troubleshooting

1 year ago
Edit for clarity: the bowden feeder screw where the filamen...

In forum General discussion, announcements and releases

1 year ago
My mini was giving me fits for a long time and I had jamming...

In forum General discussion, announcements and releases

1 year ago
Good advice already in this thread... A couple of things. I...

In forum Hardware, firmware and software help

2 years ago
@vazovsky as an alternative to sterno, a wash in the sink wi...

In forum Hardware, firmware and software help

2 years ago
I would be curious to see that calibration print on your Pru...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
On Amazon you can get a roll of ESUN cleaning filament for l...

In forum General discussion, announcements and releases

2 years ago
Neat! I was looking at that one but was concerned about sizi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Yes, what vintagepc said. If you ordered and purchased it n...

In forum Assembly and first prints troubleshooting

2 years ago
Not gonna lie, that white looks good. nice job.

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Bobstro: Excellent info on the retained values and Prusa Sli...

In forum General discussion, announcements and releases

2 years ago
perhaps this link will help. I had similar questions a whil...

In forum General discussion, announcements and releases

2 years ago
That right there is a spot on assessment. After bed cleanli...

In forum Assembly and first prints troubleshooting

2 years ago
It can happen without the Gcode modification because it take...

In forum Assembly and first prints troubleshooting

2 years ago
Felix: Your right, I was honestly not trying to be an ass, ...

In forum Assembly and first prints troubleshooting

2 years ago
I have used the filament guide that Crawlerin posted since r...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 15
Share: