Activity
 
Notifications
Clear all
OPK
OPK
Group: Registered
Joined: 2018/06/13
Trusted Member
3
1. I have a Mean Well UHP350 power supply; same issue. 2. Th...

In forum Hardware, firmware and software help

2 years ago
Any comments from Prusa? I will revert tonight to 3.7.1 as I...

In forum Hardware, firmware and software help

2 years ago
Any Prusa reply to this? I never see when there r replies to...

In forum General discussion, announcements and releases

3 years ago
So am I correct to understand that nothing was blocked, but ...

In forum Print tips (Archive)

3 years ago
For these PETG projects that refuse to let go of the PEI she...

In forum General discussion, announcements and releases

3 years ago
Crap. I literally just ordered a pair on ebay, second hand o...

In forum General discussion, announcements and releases

3 years ago
Both pairs. They run in parallel to be able to handle the po...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Opening parts of the enclosure lets the smell, noise and mic...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Hi, An enclosure should be just that: closed... In order to ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Fully agree: I will NEVER run someone else's gcode, EVER. Ju...

In forum General discussion, announcements and releases

3 years ago
When I pre-ordered mine, that info was definitely not availa...

In forum General discussion, announcements and releases

3 years ago
Some thoughts: 1. Did you check if perhaps the nozzle tempe...

In forum General discussion, announcements and releases

3 years ago
Cleaning with a brass brush removes the coating? Darn, I bou...

In forum General discussion, announcements and releases

3 years ago
As promised: I used it as part of this: and remodeled the N...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Bowden Tube Blower Extruder (Enclosure) Cooling

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Link:

In forum Assembly and first prints troubleshooting

3 years ago
But dont print and install the MK3s Prusa original parts as ...

In forum Assembly and first prints troubleshooting

3 years ago
Hmm, I had to print using a sub optimal extruder setup, perh...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
@ButterworthDesign Did u put as much attention to N4 as u d...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
BIG thanks for designing the new parts. I will try to print ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Page 1 / 5
Share: