Notifications
Clear all
Uncovery
Uncovery
Group: Registered
Joined: 2018/06/11
Eminent Member
2
@dan-rogers Thanks for helping. > Ironing slowly feeds fi...

In forum How do I print this? (Printing help)

8 months ago
@ssill2 It's PLA

In forum How do I print this? (Printing help)

8 months ago
I am printing something really tiny, the heat creep should n...

In forum How do I print this? (Printing help)

8 months ago
Filament getting ground up on ironing and fine detail printi...

In forum How do I print this? (Printing help)

8 months ago
Mesh bed leveling leaves dobs of plastic behind

In forum Hardware, firmware and software help

8 months ago
Filament clogs on long prints with low layer height.

In forum Hardware, firmware and software help

9 months ago
In the attached screenshot from this URL:the link (1) is bro...

In forum PrusaSlicer

11 months ago
Hey all, can confirm that the stand-alone is broken, the nor...

In forum PrusaSlicer

11 months ago
I have webroot, disabling it does not solve the problem.

In forum PrusaSlicer

11 months ago
Sorry about forgetting this. I am running windows 10. Apart ...

In forum PrusaSlicer

11 months ago
Cannot install 2.3.0 final, says I don't have internet

In forum PrusaSlicer

11 months ago
I had the same issue, can confirm @Guy-k2. My issue was that...

In forum Hardware, firmware and software help

2 years ago
Thanks, thats very helpful, I think mine looks exactly the s...

In forum Hardware, firmware and software help

2 years ago
Thanks! How far below the bondtech gear would you say the bo...

In forum Hardware, firmware and software help

2 years ago
Filament jam below bondtech gear

In forum Hardware, firmware and software help

2 years ago
Nevermind, nozzle was too low.

In forum Assembly and first prints troubleshooting

2 years ago
Strange pattern on the first layer

In forum Assembly and first prints troubleshooting

2 years ago
Fire hazard?

In forum General discussion, announcements and releases

2 years ago
@sembazuru That sounds like a good idea. thanks!

In forum How do I print this? (Printing help)

2 years ago
Method to limit brim locations or ease removal?

In forum How do I print this? (Printing help)

2 years ago
Page 1 / 2
Share: