Notifications
Clear all
DustinJay
DustinJay
Group: Registered
Joined: 2018/05/18
Active Member
1
Idk if there is some setting I haven't changed, but this has...

In forum General discussion, announcements and releases

9 months ago
No issues with PLA; print most of my masters in it. Sometime...

In forum General discussion, announcements and releases

10 months ago
I use 3D printing for resin, urethane, and silicone casting ...

In forum General discussion, announcements and releases

10 months ago
I have both an adjustable heat gun, and a small butane torch...

In forum General discussion, announcements and releases

12 months ago
How to make use of Mosquito Magnum

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Also adding in, filament is thoroughly dried at 65C. Again, ...

In forum How do I print this? (Printing help)

2 years ago
PETG Threads Pulling Off

In forum How do I print this? (Printing help)

2 years ago
Any chance you have a heavily loaded SD card? I've noticed t...

In forum Hardware, firmware and software help

2 years ago
Yes and no. PLA will typically have a higher tensile, but is...

In forum General discussion, announcements and releases

2 years ago
I just recently went through 10 rolls of Atomic Filament PET...

In forum General discussion, announcements and releases

2 years ago
Strictly based on my personal experience: 1) Yes, the textu...

In forum General discussion, announcements and releases

3 years ago
I would suggest using your 3D printed part to make some sili...

In forum General discussion, announcements and releases

3 years ago
Guys, I may have set a MK3 record. MK3 assembled with smooth...

In forum General discussion, announcements and releases

3 years ago
Share: