Notifications
Clear all
patrizio.b
patrizio.b
Group: Registered
Joined: 2016/10/06
Trusted Member
3
there are larger nozzle fans (2cm instead of 1.5cm) also, I ...

In forum Improvements (Archive)

5 years ago
The original parts are not Misumi... if you buy the Misumi, ...

In forum Prusa i3 kit (Archive)

5 years ago
I would recommend this design with 608 bearings : as of t...

In forum Prusa i3 kit (Archive)

5 years ago
Just to confirm your statements: LMU8 / SFJ8 is indeed the...

In forum Hardware, firmware and software help

5 years ago
To use RJ4JP you have to find the right tightening of the zi...

In forum Prusa i3 kit (Archive)

5 years ago
Only SD prints are counted on 3.0.10. So before 3.0.10 we ha...

In forum Others (Archive)

5 years ago
But maybe they don't give the same infill strength at the sa...

In forum Print tips (Archive)

5 years ago
Try a new nozzle, an e3d blue sock, or a "rub" of the PEI wi...

In forum Others (Archive)

5 years ago
the mk2 obviously 🙂 x/y/z are well calibrated (no skew), f...

In forum Prusa i3 kit (Archive)

5 years ago
Messy top layer

In forum Prusa i3 kit (Archive)

5 years ago
There's no problem in having some play. New nuts on new lead...

In forum Others (Archive)

5 years ago
I do the same! (but with slic3r) 9-point cal at 170. It's no...

In forum Print tips (Archive)

5 years ago
from what i know timing belts are not supposed to run on smo...

In forum Improvements (Archive)

5 years ago
well in fact you don't increase the wobble, you just relocat...

In forum Prusa i3 kit (Archive)

5 years ago
I wonder if this kind of modification, using a bearing to ho...

In forum Prusa i3 kit (Archive)

5 years ago
can you take some pictures of the top z holders? do the lead...

In forum Prusa i3 kit (Archive)

5 years ago
You need GT2 belt. That is GT3. I've bought it from e3donlin...

In forum Others (Archive)

5 years ago
just think how you're trying to add technology, hardware, op...

In forum Others (Archive)

5 years ago
From the specs, it seems that the all-Igus solution (RJZM-x-...

In forum Hardware, firmware and software help

5 years ago
Half-twist the Y belt on idler pulley...

In forum Improvements (Archive)

5 years ago
Page 1 / 5
Share: