Notifications
Clear all
Ancientwolf
Ancientwolf
Group: Registered
Joined: 2016/10/01
Estimable Member
4
Strange banging at direction change...

In forum PrusaSlicer

2 years ago
Matt's S3D settings are night and day in difference, and are...

In forum General discussion, announcements and releases

5 years ago
You'll be glad you did. I havent had but one print lift and ...

In forum Others (Archive)

5 years ago
WD-40 is not a lubricant.

In forum Prusa i3 kit (Archive)

5 years ago
A few have managed a working method for overlaying a glass s...

In forum Others (Archive)

5 years ago
Didnt anybody notice he said at the start that his PINDA is ...

In forum Assembly and first prints troubleshooting

5 years ago
This started happening even earlier than that. It's filament...

In forum Others (Archive)

5 years ago
What are you going on about Nigel?

In forum Others (Archive)

5 years ago
I must have got lucky- I picked up both the RJZM-02-08 and t...

In forum Hardware, firmware and software help

5 years ago
I must have got lucky- I picked up both the RJZM-02-08 and t...

In forum Hardware, firmware and software help

5 years ago
Thanks Stephan!

In forum Others (Archive)

5 years ago
Okay, so Michele from the chat support gave me a hint, where...

In forum Others (Archive)

5 years ago
I haven't had a bad print from the Prusa Edition of Slic3r. ...

In forum Print tips (Archive)

5 years ago
The sheath on the one is smooth, hence press fit, vs the RJZ...

In forum Improvements (Archive)

5 years ago
Thats why I will stick with sheathed bearings as I described...

In forum Improvements (Archive)

5 years ago
As I mentioned in the improvements section, I came across: ...

In forum Hardware, firmware and software help

5 years ago
Bearings: RJZM-02-08 appears to be a good alternative?

In forum Improvements (Archive)

5 years ago
Searching the forum for 115200 yielded some results.

In forum Software (Archive)

5 years ago
SMH... Didnt even catch that... *sigh*

In forum Print tips (Archive)

5 years ago
Have you tried the Prusa Edition of Slic3r? Could solve all ...

In forum Print tips (Archive)

5 years ago
Page 1 / 7
Share: