Notifications
Clear all
Bioluminous
Bioluminous
Group: Registered
Joined: 2018/03/25
Trusted Member
3
I know, but I just wanted to thank you, nonetheless. I'm alw...

In forum PrusaSlicer

2 weeks ago
And just like that...installed the new version and everythin...

In forum PrusaSlicer

2 weeks ago
I, too, wish there was a way to tell PrusaSlicer to make mor...

In forum PrusaSlicer

2 weeks ago
The issue I was having with temp being reduced to 260 I trac...

In forum General discussion, announcements and releases

3 weeks ago
Well after using the SL1 for over a year now, I have better ...

In forum General discussion, announcements and releases

4 weeks ago
@milehigh3der Thanks for the suggestions. I'll fool around w...

In forum General discussion, announcements and releases

1 month ago
@john-6 Meh, the default profile needs some work. Parts look...

In forum General discussion, announcements and releases

1 month ago
If you want non-organic modeling, using Shapr3D on an iPad t...

In forum General discussion, announcements and releases

1 month ago
The new Prusament PC Blend Carbon Fiber and PrusaSlicer Prof...

In forum General discussion, announcements and releases

1 month ago
And following-up after having used this for about a year (al...

In forum General discussion, announcements and releases

5 months ago
I posted the following a long time ago and got one response ...

In forum General discussion, announcements and releases

5 months ago
Need help with making profile for MakerGear M3-ID

In forum PrusaSlicer

8 months ago
I agree - the top of the build plate should be angled to all...

In forum General discussion, announcements and releases

8 months ago
I know this is an old post, and you likely have already foun...

In forum PrusaSlicer

11 months ago
I guess I don’t understand the idea of open source on the SL...

In forum General discussion, announcements and releases

12 months ago
@hamza-b Wondering if and when you purchased the X1-K and if...

In forum General discussion, announcements and releases

12 months ago
Following up to my original post, I purchased the SL1/CW1 ki...

In forum General discussion, announcements and releases

1 year ago
I have had good luck printing small parts with the new Prusa...

In forum General discussion, announcements and releases

1 year ago
SL1 / CW1 Requests Super-Thread

In forum General discussion, announcements and releases

1 year ago
I have both the Photon and the Photon S as well as the SL1. ...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 4
Share: