Prusa3D Forum

tj.d2

Group: Registered

Joined: 2018/03/23

Active Member

	Mine got worse this morning, flashing multiple times in a ro... In forum Assembly and first prints troubleshooting	10 months ago
	Mine just did that, actually it was blinking before the prin... In forum Assembly and first prints troubleshooting	10 months ago
	I had the same problem. Any PLA I tried stringed excessively... In forum Assembly and first prints troubleshooting	2 years ago
	I am having problems as well. I had a failed print (clog) c... In forum Hardware, firmware and software help	2 years ago
	What brand of 3D Pen do you recommend? In forum General discussion, announcements and releases	2 years ago
	You may have a similar problem to mine. I run into extruder ... In forum Hardware, firmware and software help	3 years ago
	I had some minor leveling issues a couple of weeks ago (righ... In forum Others (Archive)	3 years ago
	TJ I printed the frog last night with some super cheap PLA a... In forum Others (Archive)	3 years ago
	Still no luck with the Prusa Silver at .05mm Today I used th... In forum Others (Archive)	3 years ago
	Anyone else specifically running into problems printing with... In forum Others (Archive)	3 years ago
	I have been running into problems with .05mm height too. Ev... In forum Others (Archive)	3 years ago

Forum Statistics

397 Forums

34.5 K Topics

252.4 K Posts

57 Online

172.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts Mark all read

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed