karl-herbert
karl-herbert
Group: Registered
Joined: 2018/03/05
Illustrious Member
To be on the safe side, I would check the plug contacts on t...

In forum Hardware, firmware and software help

1 day ago
@jeremy-r5 Do you have a multimeter and can you check the vo...

In forum Hardware, firmware and software help

1 day ago
@jeremy-r5 Try to use a different SD card.

In forum Hardware, firmware and software help

1 day ago
@blatti Make sure the blade fits well, otherwise the selecto...

In forum General discussion, announcements and releases

1 day ago
As @bogdanh mentioned: You can have problems with any printe...

In forum General discussion, announcements and releases

1 day ago
I rather suspect a defect on the printer. Normally a slicer ...

In forum Hardware, firmware and software help

1 day ago
@jmh714 "Now, I'm wondering with new version of MK3S+ would ...

In forum General discussion, announcements and releases

1 day ago
To the subject IR filament sensor, Prusa writes: I think i...

In forum Hardware, firmware and software help

1 day ago
Du könntest im PrusaSlicer beim Gcode Endescript ein Entlade...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

1 day ago
Hello and welcome to the Prusaforum! You will find numerous ...

In forum Assembly and first prints troubleshooting

1 day ago
@jmh714 Jakub has already written something about this: wbr...

In forum General discussion, announcements and releases

1 day ago
@clemens-m Servus Clemens, hat sich Deine Taktiv bewährt? Ha...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

2 days ago
@sven-6 Freut mich, dass es bei Dir auch so gut klappt 👍 Ic...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

2 days ago
@sebastian-w8 I would consider installing Klipper or a 32-bi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 days ago
I use "UHU plast special 45880" for gluing plastic. Works qu...

In forum General discussion, announcements and releases

2 days ago
@felix-ferdinand Ergänzung: Den Thermistor kannst Du mit ein...

In forum Hilfe zur Hardware, Firmware und Software

2 days ago
Hallo und willkommen im Prusaforum! Stichwort "Thermal Runaw...

In forum Hilfe zur Hardware, Firmware und Software

2 days ago
@mifuchs Bei diesem besagten Filament und auch einigen ander...

In forum Hilfe zur Hardware, Firmware und Software

3 days ago
@blauzahn Benötigst Du unbedingt PC4/M10 Varianten. Bei Fest...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

3 days ago
My Raspberry Pi4 would be happy to do some work for the prin...

In forum General discussion, announcements and releases

3 days ago
Page 2 / 315
Share:

Please Login or Register