Activity
 
Notifications
Clear all
Robin
Robin
Group: Registered
Joined: 2018/02/16
Estimable Member
4
A bit more info for you here. I started with hairspray as a...

In forum General discussion, announcements and releases

1 year ago
@gary-a2 You will see a blue trace line on the sliced image ...

In forum PrusaSlicer

2 years ago
once sliced you can go to the bottom and show the travel of ...

In forum PrusaSlicer

2 years ago
Not sure if this is what your trying to do. You can set a p...

In forum General discussion, announcements and releases

2 years ago
I believe the bearings are covered here

In forum Hardware, firmware and software help

2 years ago
It’s not sandpaper

In forum Assembly and first prints troubleshooting

2 years ago
Get some Scotch brite pads. You may need the fine ones for t...

In forum Assembly and first prints troubleshooting

2 years ago
The PINDA as said only works on the steel sheet its self. Th...

In forum Print tips (Archive)

2 years ago
With mine i just select preheat setting for the filament typ...

In forum Assembly and first prints troubleshooting

2 years ago
It looks like your printing on the textured build sheet? If ...

In forum Print tips (Archive)

2 years ago
Check and see if you have the branded or none branded bearin...

In forum Hardware, firmware and software help

2 years ago
Misumi bearings if bought from a supplier will normally come...

In forum Assembly and first prints troubleshooting

2 years ago
Think the low temp is about 170degrees may be a bit more. Pr...

In forum How do I print this? (Printing help)

2 years ago
Eccellent answer from bobstro above covers most of what you ...

In forum How do I print this? (Printing help)

2 years ago
I only use the printed type bearing holders now. The U bolts...

In forum Improvements (Archive)

2 years ago
If you start hearing a clunk or thud as the Y xais moves its...

In forum Assembly and first prints troubleshooting

2 years ago
for a mod to the Y axis bearings i can recoment this type of...

In forum Assembly and first prints troubleshooting

2 years ago
Is the power fail on the print to total? You should not get...

In forum Assembly and first prints troubleshooting

2 years ago
A few questions What slicer are you using? What settings are...

In forum Assembly and first prints troubleshooting

2 years ago
What is the make and type of filament and is it old or new

In forum Hardware, firmware and software help

3 years ago
Page 1 / 8
Share: