Notifications
Clear all
nuggetz
nuggetz
Group: Registered
Joined: 2016/09/19
Eminent Member
2
How to play sounds/beeps on mini?

In forum General discussion, announcements and releases

2 years ago
@rat_patrol Ok, that makes sense. I just noticed that the s...

In forum General discussion, announcements and releases

2 years ago
What's with the 95% flow rate?

In forum General discussion, announcements and releases

2 years ago
Bump. Is there a good Cura profile out? I dont feel like tw...

In forum Cura, Simplify3D, Kisslicer, ...

2 years ago
I experience this too on occasion. Sometimes I even get a wh...

In forum Hardware, firmware and software help

2 years ago
Not sure if this is a filament related thing or firmware but...

In forum General discussion, announcements and releases

2 years ago
@cdrskullbu Your pinda probably died like mine did 3 days in...

In forum General discussion, announcements and releases

2 years ago
@olef I’m not sure I would have ordered a mini if I knew I c...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Has every single Prusa printer release been locked down init...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Simplify3D profile?

In forum Hardware, firmware and software help

2 years ago
When will we have Octoprint support?

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I think the main reason this profile has such good results i...

In forum General discussion, announcements and releases

4 years ago
What are the equivalent M commands for setting accel for per...

In forum Prusa i3 kit (Archive)

4 years ago
Been running LA with very good results but I wanted to discu...

In forum Others (Archive)

4 years ago
Thank you sir.

In forum Software (Archive)

5 years ago
So whats the trick to importing the various configuration in...

In forum Software (Archive)

5 years ago
Subbing to this.

In forum Improvements (Archive)

5 years ago
I just tightened up my Y belt as it seemed a bit too loose b...

In forum Others (Archive)

5 years ago
I'd like to know how to get S3D to heat up both in parallel ...

In forum General discussion, announcements and releases

5 years ago
Trying flex material makes me never want to use it again. Ha...

In forum Print tips (Archive)

5 years ago
Page 1 / 2
Share: