Activity
 
Notifications
Clear all
K7ZPJ
K7ZPJ
Group: Registered
Joined: 2018/01/28
Estimable Member
4
Firmware 4.3.3 From the main screen: Settings > HW Setup...

In forum Hardware, firmware and software help

7 hours ago
Bondtech has updated their upgrade instructions for use with...

In forum General discussion, announcements and releases

1 day ago
Replacing the just the super pinda works fine with no issues...

In forum Hardware, firmware and software help

2 days ago
Palette 2(s) works well with the mini(+). Also, the mini(+...

In forum General discussion, announcements and releases

4 weeks ago
There is an Octoprint plug-in that prompts your for which fi...

In forum Assembly and first prints troubleshooting

7 months ago
@oleg Both the Mini+ and the MK3S+ support wood / metal fill...

In forum General discussion, announcements and releases

10 months ago
All 3d printers are going to take a bit of "tinkering" to ge...

In forum General discussion, announcements and releases

10 months ago
The RPi 4B 8gb is a 64 bit board and takes a different Octpi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I am using a Pimoroni Fan Shim to cool the RPI 4B 2 gb that ...

In forum General discussion, announcements and releases

1 year ago
Both the Mini and the MK3s are really good printers. Being y...

In forum General discussion, announcements and releases

1 year ago
@bruce-1 Did you check the status of the filament sensor in ...

In forum Hardware, firmware and software help

1 year ago
@ray-b2 Firmware version 3.90 enables the cutter and gives y...

In forum General discussion, announcements and releases

1 year ago
@smoking_rubber The Pi3B+ will be fine. You just install ...

In forum General discussion, announcements and releases

1 year ago
@mssj I use the DIY canvas hub instead of the pre-loaded on...

In forum General discussion, announcements and releases

1 year ago
@mssj Disable the filament sensor in firmware. Detach the MM...

In forum General discussion, announcements and releases

1 year ago
Voxel Factory: Printed Solid:

In forum General discussion, announcements and releases

1 year ago
@vintagepc The voltage is staying stable at 3.85V and doesn'...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@3d-gussner I am having mixed results. Using 1K of resist...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
No filament: 4.4V filament: 0.4V Firmware version 3.9.0-RC3 ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@ilja-coveliers Check the prusaprinters world map to see if ...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 8
Share: