Grandpa Joe
Grandpa Joe
Group: Registered
Joined: 2018/01/26
Eminent Member
2
@cwbullet Thanks. I went ahead and replaced the heat bed.

In forum General discussion, announcements and releases

1 month ago
Thanks. I ended up with a new circuit board and a new heat ...

In forum General discussion, announcements and releases

3 months ago
Burned wires, Melted plastic

In forum General discussion, announcements and releases

4 months ago
@neophyl I use Shapr3D. iPad Pro and Apple Pencil. Works we...

In forum PrusaSlicer

11 months ago
Slicr3D Best Infill

In forum General discussion, announcements and releases

11 months ago
This is what was ordered REP-E3D-40W MK2S E3D 40W 12V Heate...

In forum General discussion, announcements and releases

2 years ago
Not sure. I will try to find out.

In forum General discussion, announcements and releases

2 years ago
MK2.5 Thermal Runaway

In forum General discussion, announcements and releases

2 years ago
I am also having "Thermal Runaway" errors. They started rec...

In forum Assembly and first prints troubleshooting

2 years ago
How far past the hot end collet should the PTFE tube extend?

In forum Assembly and first prints troubleshooting

2 years ago
Sorry, I mistyped. I have the 2.5 already. I am wondering...

In forum General discussion, announcements and releases

2 years ago
Are the extruder and filament sensors the only difference be...

In forum General discussion, announcements and releases

2 years ago
I usually don’t have a problem with them sticking very much,...

In forum How do I print this? (Printing help)

2 years ago
I am using Shapr and sometimes the dimensions do not transfe...

In forum General discussion, announcements and releases

2 years ago
Units in Slic3r

In forum Hardware, firmware and software help

2 years ago
I have been using the Shapr3D program on my iPad Pro for sev...

In forum General discussion, announcements and releases

2 years ago
I am hoping that the new filament is better than the one I r...

In forum General discussion, announcements and releases

2 years ago
Is the MMU2 being shipped yet?? I have been waiting - - - -...

In forum General discussion, announcements and releases

2 years ago
Unboxing would be great - if I ever get mine. When are they ...

In forum General discussion, announcements and releases

2 years ago
Printing job stops.

In forum Hardware, firmware and software help

2 years ago
Page 1 / 2
Share:

Please Login or Register