Prusa3D Forum

Grandpa Joe

Group: Registered

Joined: 2018/01/26

Eminent Member

	@cwbullet Thanks. I went ahead and replaced the heat bed. In forum General discussion, announcements and releases	2 months ago
	Thanks. I ended up with a new circuit board and a new heat ... In forum General discussion, announcements and releases	3 months ago
	Burned wires, Melted plastic In forum General discussion, announcements and releases	4 months ago
	@neophyl I use Shapr3D. iPad Pro and Apple Pencil. Works we... In forum PrusaSlicer	11 months ago
	Slicr3D Best Infill In forum General discussion, announcements and releases	11 months ago
	This is what was ordered REP-E3D-40W MK2S E3D 40W 12V Heate... In forum General discussion, announcements and releases	2 years ago
	Not sure. I will try to find out. In forum General discussion, announcements and releases	2 years ago
	MK2.5 Thermal Runaway In forum General discussion, announcements and releases	2 years ago
	I am also having "Thermal Runaway" errors. They started rec... In forum Assembly and first prints troubleshooting	2 years ago
	How far past the hot end collet should the PTFE tube extend? In forum Assembly and first prints troubleshooting	2 years ago
	Sorry, I mistyped. I have the 2.5 already. I am wondering... In forum General discussion, announcements and releases	2 years ago
	Are the extruder and filament sensors the only difference be... In forum General discussion, announcements and releases	2 years ago
	I usually don’t have a problem with them sticking very much,... In forum How do I print this? (Printing help)	2 years ago
	I am using Shapr and sometimes the dimensions do not transfe... In forum General discussion, announcements and releases	2 years ago
	Units in Slic3r In forum Hardware, firmware and software help	2 years ago
	I have been using the Shapr3D program on my iPad Pro for sev... In forum General discussion, announcements and releases	2 years ago
	I am hoping that the new filament is better than the one I r... In forum General discussion, announcements and releases	2 years ago
	Is the MMU2 being shipped yet?? I have been waiting - - - -... In forum General discussion, announcements and releases	2 years ago
	Unboxing would be great - if I ever get mine. When are they ... In forum General discussion, announcements and releases	2 years ago
	Printing job stops. In forum Hardware, firmware and software help	2 years ago

Page 1 / 2 Next

Forum Statistics

397 Forums

37.5 K Topics

274.1 K Posts

64 Online

55.8 K Members

Latest Post: Ticking noise at low speeds Our newest member: shayienvalliereprusa Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts Mark all read

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed