Grandpa Joe
Grandpa Joe
Group: Registered
Joined: 2018/01/26
Eminent Member
2
@cwbullet Thanks. I went ahead and replaced the heat bed.

In forum General discussion, announcements and releases

4 days ago
Thanks. I ended up with a new circuit board and a new heat ...

In forum General discussion, announcements and releases

2 months ago
Burned wires, Melted plastic

In forum General discussion, announcements and releases

3 months ago
@neophyl I use Shapr3D. iPad Pro and Apple Pencil. Works we...

In forum PrusaSlicer

9 months ago
Slicr3D Best Infill

In forum General discussion, announcements and releases

9 months ago
This is what was ordered REP-E3D-40W MK2S E3D 40W 12V Heate...

In forum General discussion, announcements and releases

2 years ago
Not sure. I will try to find out.

In forum General discussion, announcements and releases

2 years ago
MK2.5 Thermal Runaway

In forum General discussion, announcements and releases

2 years ago
I am also having "Thermal Runaway" errors. They started rec...

In forum Assembly and first prints troubleshooting

2 years ago
How far past the hot end collet should the PTFE tube extend?

In forum Assembly and first prints troubleshooting

2 years ago
Sorry, I mistyped. I have the 2.5 already. I am wondering...

In forum General discussion, announcements and releases

2 years ago
Are the extruder and filament sensors the only difference be...

In forum General discussion, announcements and releases

2 years ago
I usually don’t have a problem with them sticking very much,...

In forum How do I print this? (Printing help)

2 years ago
I am using Shapr and sometimes the dimensions do not transfe...

In forum General discussion, announcements and releases

2 years ago
Units in Slic3r

In forum Hardware, firmware and software help

2 years ago
I have been using the Shapr3D program on my iPad Pro for sev...

In forum General discussion, announcements and releases

2 years ago
I am hoping that the new filament is better than the one I r...

In forum General discussion, announcements and releases

2 years ago
Is the MMU2 being shipped yet?? I have been waiting - - - -...

In forum General discussion, announcements and releases

2 years ago
Unboxing would be great - if I ever get mine. When are they ...

In forum General discussion, announcements and releases

2 years ago
Printing job stops.

In forum Hardware, firmware and software help

2 years ago
Page 1 / 2
Share:

Please Login or Register