Uppsala CNC
Uppsala CNC
Group: Registered
Joined: 2018/01/16
Eminent Member
2
@tim-m30 Nope, first time this happened I thought it was a c...

In forum Hardware, firmware and software help

8 months ago
@tim-m30 I do indeed have an enclosure and I do see how it c...

In forum Hardware, firmware and software help

8 months ago
Extruder jams and prints fails at similar height regardless ...

In forum Hardware, firmware and software help

8 months ago
is it possible for you to check the heater voltage at the sa...

In forum Hardware, firmware and software help

3 years ago
Hi Warrawarra, are you able to check the power voltage whe...

In forum Hardware, firmware and software help

3 years ago
I would assume that since this had not started until after d...

In forum Hardware, firmware and software help

3 years ago
I though the no activity after XX minutes but still heated s...

In forum Hardware, firmware and software help

3 years ago
Okay so an update. I checked for the flickering LED on the h...

In forum Hardware, firmware and software help

3 years ago
is the Bed LED lit, while the temperature is going down? re...

In forum Hardware, firmware and software help

3 years ago
I wonder if it something where the thermistor grub screw is ...

In forum Hardware, firmware and software help

3 years ago
no problem. it was only a suggestion based on the device he...

In forum Hardware, firmware and software help

3 years ago
I would start with a wiring check- the thermistor wires are ...

In forum Hardware, firmware and software help

3 years ago
the heater might have a broken wire in the cable bundle betw...

In forum Hardware, firmware and software help

3 years ago
Loss of heating to hot end mid print

In forum Hardware, firmware and software help

3 years ago
And now you can join the rest of us, wanting to print the ne...

In forum Hardware, firmware and software help

3 years ago
Thank you! I was under the impression that some parts were m...

In forum Hardware, firmware and software help

3 years ago
And now you can join the rest of us, wanting to print the ne...

In forum Hardware, firmware and software help

3 years ago
Filament type/brand/color used for the MK3 parts?

In forum Hardware, firmware and software help

3 years ago
Go into the settings menu and disable crash detection, then ...

In forum Assembly and first prints troubleshooting

3 years ago
Random crash detection triggers

In forum Assembly and first prints troubleshooting

3 years ago
Share:

Please Login or Register