Activity
 
Pez
Pez
Group: Registered
Joined: 2018/01/08
Active Member
1
I had a "bed thermal runaway" and "bed preheat error". It ...

In forum Hardware, firmware and software help

1 year ago
I had a "bed thermal runaway" and "bed preheat error". It ...

In forum Hardware, firmware and software help

1 year ago
I had a "bet thermal runaway" and "bed preheat error". It ...

In forum Hardware, firmware and software help

1 year ago
Here is a 7-second video of a y-axis crash detect ... they h...

In forum Hardware, firmware and software help

3 years ago
My stats: build = Kit slicer = PrusaControl belt tension =...

In forum Hardware, firmware and software help

3 years ago
> Why do you think the Spiral Wrap of the Extruder (X-Axi...

In forum Hardware, firmware and software help

3 years ago
Oliver wrote ... "the Nylon Filament and the spiral cable wr...

In forum Hardware, firmware and software help

3 years ago
I looked at the "Fail Stats", and all the crashes are Y (sam...

In forum Hardware, firmware and software help

3 years ago
"Crash detected" message during print

In forum Hardware, firmware and software help

3 years ago
It looks like I was able to solve this by lowering the PINDA...

In forum Assembly and first prints troubleshooting

3 years ago
Yes, I tested the PINDA probe and I can get the red light to...

In forum Assembly and first prints troubleshooting

3 years ago
Sean - thanks for the help. Here is the photo you requested...

In forum Assembly and first prints troubleshooting

3 years ago
Yes, during 9. Preflight check, I adjusted the nozzle to the...

In forum Assembly and first prints troubleshooting

3 years ago
Extruder nozzle stuck in screw hole during Wizard calibratio...

In forum Assembly and first prints troubleshooting

3 years ago
Share:

Please Login or Register